OM-1833-001w_SL.pdf - 第52页
(2) Before setting the tape feeder onto the bank feeder change cart, make sure that there are no such foreign objects as dirt or dust on the feeder base on the upper section of the cart. (3) Attach the tape feeder to the…
Note
(a) The partition panel pitch (bay) should be 21 mm in the reel holding section
and the thickness of the partition panel should be 0.8 mm.
(b) When 2 pitches or more are used, remove the partition panel.
Notice
When removing or setting the partition panel, take care not
to hurt your ngers.
リール保持部
2 Pitch
1 Pitch
Partition Panel
Reel Holding Section
Large Reel Set Position
Small Reel Set Position
Fig. C2
1504-001
3.1 Tape Feeder Attachment Procedure
OM-1833
3-3
(2) Before setting the tape feeder onto the bank feeder change cart, make sure
that there are no such foreign objects as dirt or dust on the feeder base on the
upper section of the cart.
(3) Attach the tape feeder to the feeder base with the specied feeder No..
Notice
•
If the hook section at the end of the tape feeder is bumped, it
will be deformed, and so cause a pick-up error.
Take care not to bump the hook section.
•
Set the tape feeder onto the slot with the correct Fdr. No..
If it is not set correctly, the component might enter the head
section.
(4) Hold the grip and insert the tape feeder end so that it is aligned with the
feeder base rail.
Then push the rear of the grip forward and make sure that the tape feeder has
been securely set.
Grip
Fig. C3
Notice
Set the tape feeder securely onto the rail of the feeder base.
1504-001
3.1 Tape Feeder Attachment Procedure
OM-1833
3-4
(5) Hold the grip, and insert it forward carefully until a click sound is heard.
At the same time, make sure that the tape feeder connector has been securely
connected.
Connector
Fig. C4
Notice
•
If a tape feeder is used in a lifted state, the machine (Yamaha
modular mounter (chip mounter)) may be damaged or a pickup
malfunction may occur.
Mount the tape feeder securely on the feeder base.
•
Remove the unused tape feeders from the bank feeder change
cart.
Also, if the machine has been operated for a long time with
such unused tape feeders attached, then the tape will have
been slackened, which might cause a pick-up error.
1504-001
3.1 Tape Feeder Attachment Procedure
OM-1833
3-5