OM-1833-001w_SL.pdf - 第31页
• For the T aping Components, fused bands of the cover tape should be formed only on the left and right of pockets' outside. * T aping Components like the following can not be dealed with the SL feeders. Cover tape …
* Taping Components like the followings can not be dealed with the SL feeders.
The cover tape is
concaved downward.
Embossed tape
Cover tape
Carrier tape
Fig. A16
The cover tape is concaved
downward around the pocket.
Enlarge
Fig. A17
•
For the Taping Components, the top surface of the carrier tape should be at
and no dip in the center of the surface.
And, in case of that each distance between pockets is narrow, the top surface
of the carrier tape should be higher than any components stored in the taping
carrier.
* Taping Components like the followings can not be dealed with the SL feeders.
Pocket
Fused bands of
cover tape
Embossed tape
The top surface of the carrier tape is not flat,
and each area between pockes is dipped downward.
Fig. A18
Cover tape
Embossed tape
Each distance between pockets is narrow, and the top surface of
the carrier tape is not higher than the top surface of stored
components in relation to the taper angle of forming embossed
pocket. (No clearance)
Fig. A19
1.3 Taping Specications
OM-1833
1-10
•
For the Taping Components, fused bands of the cover tape should be formed
only on the left and right of pockets' outside.
* Taping Components like the following can not be dealed with the SL feeders.
Cover tape
Fused hands of cover tape
Carrier tape
Other than left and right of pockets' outside, fused spots exist on the surface of between pockets.
(Also, any Taping Components with fused spots in non-periodical manner can not be dealed with the SL feeders.)
Fig. A20
•
Taping components should not have any creased part on the carrier tape.
* For Taping Components with any creased portion like the followings, the cover
tape processing might not work normally.
Creased parts
Creased parts
Fig. A21
1.3 Taping Specications
OM-1833
1-11
1.4 Types Tape Feeders
Table A3
Tape Feeder
Tape Width ×
Feed Pitch (mm)
Cover Tape
Processing
Section Type
Types of
Tape
Mass
(kg)
Power Supply
Barcode
Label Color
SL-48085
8 mm Dual
Tape Feeder
(Note)
8 × 1, 2 S
Paper
Embossed
3.5 DC24V
±
10% Blue + White
SL-48086
8 mm Dual
Tape Feeder
8 × 2, 4 M
Paper
Embossed
3.5 DC24V
±
10% Yellow + White
SL-48087
8 mm Dual
Tape Feeder
8 × 2, 4 L
Paper
Embossed
3.5 DC24V
±
10% Pink + White
SL-48088
8 mm Dual
Tape Feeder
8 × 4 LL
Paper
Embossed
3.5 DC24V
±
10% White
Note
SL-48085 is applicable to 1 mm pitch tape.
732
312
20.2
Unit : mm
Fig. A12 8 mm Dual Tape Feeder
1504-001
1.4 Types Tape Feeders
OM-1833
1-12