OM-1833-001w_SL.pdf - 第73页

1504-001 5. Maintenance 5.1 Precautions before Maintenance This describes the check, cleaning, and adjustment for tape feeders operating in good conditions. A full and periodical maintenance of the tape feeder is recomme…

100%1 / 122
The lane where a component shortage has occurred is notied with the dot display .
When the succeeding component reload tape has not been setup after the tape end has been judged and
the remaining tape forcible feeder operation has been completed, this component shortage indication
is displayed to notify the operator to reload the component.
Component Shortage Notication
Repeated
4.3.3 Component Shortage Notication
1504-001
4.3 Error Code, Component Shortage Notication
OM-1833
4-16
1504-001
5. Maintenance
5.1 Precautions before Maintenance
This describes the check, cleaning, and adjustment for tape feeders operating in
good conditions.
A full and periodical maintenance of the tape feeder is recommended.
CAUTION
Only trained persons should perform maintenance,
both carefully and according to the specied
procedures.
5. Maintenance
OM-1833
5-1
5.2 Preparation for Maintenance
Preparation for Cleaning and Oiling
•
Rag (Extra Cloth)
Use a rag made of such material (cotton, etc.) that produces as less waste thread
as possible.
A clean rag must be used depending on a spot to be cleaned.
Notice
The remaining waste thread if any will cause the machine to break
down.
•
Alcohol
Do not use alcohol on unspecied locations.
•
Air Gun
Do not use the air gun for any spots other than the specied ones.
If dirt and dust are dispersed, moving mechanisms, causing the tape feeder to
break down.
•
Vacuum Cleaner
If the suction hole of the vacuum cleaner is changed to a smaller one, some
spots can be cleaned more easily.
•
Cotton Applicator (SIGMA-G5/G5S/F8 Main Machine Line Accessory)
It is used for removing dirt stuck onto the sensor section.
•
Greasing Jig (SIGMA-G5/G5S/F8 Main Machine Line Accessory)
Grease is applied using this syringe type jig.
(When grease for one division on the gauge is injected, grease of 0.1 ml is
applied).
•
Greasing Jig Nozzle (SIGMA-G5/G5S/F8 Main Machine Line Accessory)
Grease is applied using this syringe type jig.
•
Grease
Use MOLYNOC GREASE AP1 (NIPPON OIL CORPORATION) or its
equivalent.
1504-001
5.2 Preparation for Maintenance
OM-1833
5-2