OM-1833-001w_SL.pdf - 第46页

1504-001 2.4 T ape End Processing Procedure Notice Depending on the tape end shape, it can’t be correctly loaded. In order to attach the tape, make sure to process the tape end in advance. Before Tape End Processing Afte…

1504-001

2.3 Component Reload Tape Attachment Procedure

(6) Press down the lever to lift the roller and insert the tape about 10mm, so that

the tape is engaged with the sprocket (3) gear.

Roller

Fig. B20

(7) Then, the setup of the succeeding component reload tape is completed.

Preceding Tape

Succeeding Componet

Reload Tape

Fig. B21

OM-1833

2-9

1504-001

2.4 Tape End Processing Procedure

Notice

Depending on the tape end shape, it can’t be correctly loaded.

In order to attach the tape, make sure to process the tape end in

advance.

Before Tape End Processing After Tape End Processing

Before Tape End Processing

Paper Tape

Embossed

Tape

After Tape End Processing

Fig. B22

2.4 Tape End Processing Procedure

OM-1833

2-10

1504-001

2.4 Tape End Processing Procedure

2.4.1 Paper Tape End Processing Procedure

Procedure

(1) Insert the tape into the jig until the tape end reaches the end section.

Note

Hold the jig with the roller side turned up.

(The side where a pin is viewed, should be turned up).

Label

Insert it to the end.

Use the right side (P)

on the unit.

Tape

Fig. B23

(2) Push the jig into the unit and atten the tape end.

Push the jig

into the unit.

Fig. B24

(3) Make sure that the tape does not come out.

Fig. B25

OM-1833

2-11