OM-1833-001w_SL.pdf - 第60页

4.2.4 Minimum Pitch Feed Operation This is used when the tape with a new reel is to be set on the tape feeder and the chip component center is aligned with the pick-up position. This feeds the tape xed with a minimum pi…

4.2 Operation of Operation Panel

4.2.1 Subject Lane Selection

Press the button to select the lane.

Each pressing of this button moves the dot indication

to the left or right in the

indicator.

4.2.2 Feed Pitch Selection

Procedure

(1) Press the button to select the lane.

(2) Press the

button for 2 seconds or more to ash the display section.

When the display ashes, press the

button and then press the button.

(3) Press the

button and keeping this condition, press the button or

button to set the feed pitch.

Note

When the button is pressed, the pitch changes bigger one.

When the button is pressed, the pitch changes smaller one.

Reference

Refer to "1.3 Types of Tape Feeders " for the pitch amount.

(4) Change the pitch until the feed pitch to be set is reached, and then, press the

button.

The indication stops ashing and the indicator continuously stays on, when

the pitch is set.

4.2.3 Set Pitch Feeding Operation

Procedure

(1) Press the button to select the lane.

(2) Press the

button and at the same time, press the button.

(3) Within 2 seconds, release your nger from the

button only and keep

pressing the

button.

(4) Using the ON/OFF operation of the

button, execute the 1 pitch feed

operation.

Repeating the ON/OFF operation of the

button can continue the feed

operation.

(5) Release your nger from the

button to end the operation.

1504-001

4.2 Operation of Operation Panel

OM-1833

4-3

4.2.4 Minimum Pitch Feed Operation

This is used when the tape with a new reel is to be set on the tape feeder and the

chip component center is aligned with the pick-up position.

This feeds the tape xed with a minimum pitch.

Note

(a) According to the set feed pitch, the minimum feed pitch is changed.

•

When the feed pitch is 1 mm : Minimum feed pitch = 1 mm

•

When the feed pitch is 2 mm or more : Minimum feed pitch = 2 mm

(b) In the case of minimum feed pitch, the tape is not fed in the rst start

operation. This is because servo-ON processing is performed for the tape

feed servo-motor to return to the home position from any position.

In this case, repeat the operation within 1 second.

The servo ON condition is continued for 1 second.

Procedure

(1) Press the button to select the lane.

(2) Using the ON/OF operation of the

button, execute the minimum feed

pitch.

Repeating the ON/OFF operation of the

button can continue the

minimum feed pitch.

1504-001

4.2 Operation of Operation Panel

OM-1833

4-4

4.2.5 Set Pitch Returning Operation

Procedure

(1) Press the button to select the lane.

(2) Press the

button and at the same time, press the button.

(3) Within 2 seconds, release your nger from the

button only and keep

pressing the

button.

(4) Using the ON/OFF operation of the

button, execute the 1 pitch feed

operation.

Repeating the ON/OFF operation of the button can continue the feed

operation.

(5) Release your nger from the

button.

1504-001

4.2 Operation of Operation Panel

OM-1833

4-5