Horizon UserManualV6.pdf - 第26页
STAGE 4A Fit Squeegees Fitting Squeegees If ProFlow was used when running the last product, carry out the ProFlow to Squeegee Replacement Procedure, see Technical Reference Manual, Squeegee Module Chapter - Replacement P…
5. Use either the Incr. and Decr. keys (F6 - F7) or the forward slash key (/) on
the keyboard to change the parameter value.
Save Next Previous
Incr. Decr.
Exit
NOTE
A definition of all editable parameters is contained at the end of this chapter.
6. Select Save (F2). The message ‘Saving fiducial data - Please wait
Board data file saved’ is displayed.
Save
Next Previous Incr. Decr. Exit
7. Repeat Steps 4 - 6 for the remaining parameters.
8. Select Exit (F8).
Save Next Previous Incr. Decr.
Exit
Software Version 6 User Manual 1.9
MACHINE PROGRAMMING
STAGE 3
STAGE 4A
Fit Squeegees
Fitting Squeegees If ProFlow was used when running the last product, carry out the ProFlow to
Squeegee Replacement Procedure, see Technical Reference Manual, Squeegee
Module Chapter - Replacement Procedures.
1. Select Setup (F6).
Run Head Paste
Load
Clean
Screen
Adjust
Setup
Monitor Maint.
2. Select Setup Squeegee (F4).
Mode Load
Data
Edit
Data
Setup
Squeegee
Change
Screen
Change
Tooling
Change
Language
Exit
3. Select Change Squeegee (F1).
Change
Squeegee
Calibrat
Heights
Exit
4. Lift the front printhead cover.
5. Before fitting the squeegees to the machine, fix the paste deflectors to each
end of the squeegee assemblies, using the screws supplied. Ensure that the
bottom edge of the deflector is above the lower edge of the squeegee blade.
The setting of the paste deflectors is carried out later in this chapter.
NOTE
The deflectors are handed so care must be taken to fix the correct deflector to
each end of the squeegee assemblies.
1.10 User Manual Software Version 6
MACHINE PROGRAMMING
STAGE 4A
The front and rear squeegees must be fitted in the correct positions. Each
squeegee has a keyway machined into it to ensure that it cannot be incorrectly
fitted.
Software Version 6 User Manual 1.11
MACHINE PROGRAMMING
STAGE 4A
NOTE
To prevent incorrect orientation when fitting squeegees, the locking screws on
the rear squeegee are positioned wider apart than those on the front
squeegee. Keyway slots are also in different positions.
Rear Squeegee
Front Squeegee
Rear Squeegee (Front View)
Front Squeegee (Front View)
Squeegee Blade Squeegee Holder
Locking Screw Keyway
Locking Screw
FittoRear
Squeegee Mount
FittoFront
Squeegee Mount
Side View of Squeegee
and Squeegee Mounts
Side View of Squeegee
and Squeegee Mounts