Horizon UserManualV6.pdf - 第42页
4. Use the Incr. and Decr. keys (F6 - F7), or the forward slash key (/) on the keyboard, to change the parameter value. Save Next Previous Incr. Decr. Exit 5. Select Save (F2). The message ‘Saving fiducial data - Please …
STAGE 5A
Tooling Setup -
Magnetic Pillars
Board Stop Setting up the board stop position is automatically done using the board
dimensions previously set in the board parameter file. If adjustment is necessary
proceed as follows:
1. Select Change Tooling (F6).
Mode Load
Data
Edit
Data
Setup
Squeegee
Change
Screen
Change
Tooling
Change
Language
Exit
The print carriage and the under screen cleaner are moved to the rear.
The Change Tooling Parameters window is displayed:
NOTE
If the remote board stop is fitted the Board Stop X and Board Stop Y parameters
are replaced by Remote Board Stop X.
These parameters are automatically calculated from the board size parameters
that were entered in the product file. If they need adjustment to re-position the
board stop for any reason, ie any routing on the board edge or a badly positioned
image on the screen, this can be done now.
2. Select Adjust (F1).
Adjust
Open
Cover
Home
Cleaner
Board
Stop
Full
Width
Load
Width
Print
Height
Exit
3. Use the Next and Previous keys (F4 - F5) to highlight each parameter.
Save
Next Previous
Incr. Decr. Exit
Software Version 6 User Manual 1.25
MACHINE PROGRAMMING
STAGE 5A
Change Tooling Parameters
BOARD WIDTH
BOARD STOP X
BOARD STOP Y
216.0
125.0
142.6
mm
mm
mm
4. Use the Incr. and Decr. keys (F6 - F7), or the forward slash key (/) on the
keyboard, to change the parameter value.
Save Next Previous
Incr. Decr.
Exit
5. Select Save (F2). The message ‘Saving fiducial data - Please wait
Board data file saved’ is displayed.
Save
Next Previous Incr. Decr. Exit
6. Select Exit (F8).
Save Next Previous Incr. Decr.
Exit
7. Select Home Cleaner (F3).
Adjust Open
Cover
Home
Cleaner
Board
Stop
Full
Width
Load
Width
Print
Height
Exit
8. Select Exit (F8).
Adjust Open
Cover
Remove
Cleaner
Board
Stop
Full
Width
Load
Width
Print
Height
Exit
Magnetic Pillars
CAUTION
BOARD CLAMPS. Care must be taken to ensure that the board clamps
are not damaged when removing or replacing tooling.
1. Select Change Screen (F5).
Mode Load
Data
Edit
Data
Setup
Squeegee
Change
Screen
Change
Tooling
Change
Language
Exit
The message ‘Open Front Cover and Remove Screen’ is displayed.
1.26 User Manual Software Version 6
MACHINE PROGRAMMING
STAGE 5A
WARNING
BOARD CLAMPS. EXTREME CARE MUST BE EXERCISED WHEN
WORKING IN THE TOOLING AREA OF THE MACHINE TO AVOID
INJURY. THE FOILS ON THE FRONT AND REAR BOARD CLAMPS
ARE VERY SHARP.
2. Open the front printhead cover.
3. Remove the stencil from the printer.
4. Close the front printhead cover.
5. Press the System button.
Software Version 6 User Manual 1.27
MACHINE PROGRAMMING
STAGE 5A