Horizon UserManualV6.pdf - 第59页
42. Select Exit (F8). Adjust Open Cover Remove Cleaner Board Stop Full Width Load Width Print Height Exit 43. Go to Stage 6. Software Version 6 User Manual 1.43 MACHINE PROGRAMMING STAGE 5B
37. Load the appropriate stencil for the product file loaded, ensuring the correct
orientation of the stencil.
38. Lower the front printhead cover.
39. Press the System button.
40. Select Change Screen (F2).
Adjust
Change
Screen
Board
Clamps
Set
Stop
Exit
41. Select Exit (F8).
Adjust Change
Screen
Board
Clamps
Set
Stop
Exit
1.42 User Manual Software Version 6
MACHINE PROGRAMMING
STAGE 5B
42. Select Exit (F8).
Adjust Open
Cover
Remove
Cleaner
Board
Stop
Full
Width
Load
Width
Print
Height
Exit
43. Go to Stage 6.
Software Version 6 User Manual 1.43
MACHINE PROGRAMMING
STAGE 5B
STAGE 5C
Tooling Setup - Dedicated Tooling System
CAUTION
BOARD CLAMPS. Care must be taken to ensure that the board clamps
are not damaged when removing or replacing tooling.
1. Select Change Screen (F5).
Mode Load
Data
Edit
Data
Setup
Squeegee
Change
Screen
Change
Tooling
Change
Language
Exit
The message ‘Open Front Cover and Remove Screen’ is displayed.
2. Open the front printhead cover.
3. Remove the stencil from the printer.
1.44 User Manual Software Version 6
MACHINE PROGRAMMING
STAGE 5C
WARNING
BOARD CLAMPS. EXTREME CARE MUST BE EXERCISED WHEN
WORKING IN THE TOOLING AREA OF THE MACHINE TO AVOID
INJURY. THE FOILS ON THE FRONT AND REAR BOARD CLAMPS
ARE VERY SHARP.