Horizon UserManualV6.pdf - 第52页
4. Close the front printhead cover. 5. Press the System button. 6. Select Change Tooling (F6). Mode Load Data Edit Data Setup Squeegee Change Screen Change Tooling Change Language Exit The print carriage and the under sc…
STAGE 5B
Tooling Setup -
Vacuum
CAUTION
BOARD CLAMPS. Care must be taken to ensure that the board clamps
are not damaged when removing or replacing tooling.
1. Select Change Screen (F5).
Mode Load
Data
Edit
Data
Setup
Squeegee
Change
Screen
Change
Tooling
Change
Language
Exit
The message ‘Open Front Cover and Remove Screen’ is displayed.
2. Open the front printhead cover.
3. Remove the stencil from the printer.
Software Version 6 User Manual 1.35
MACHINE PROGRAMMING
STAGE 5B
WARNING
BOARD CLAMPS. EXTREME CARE MUST BE EXERCISED WHEN
WORKING IN THE TOOLING AREA OF THE MACHINE TO AVOID
INJURY. THE FOILS ON THE FRONT AND REAR BOARD CLAMPS
ARE VERY SHARP.
4. Close the front printhead cover.
5. Press the System button.
6. Select Change Tooling (F6).
Mode Load
Data
Edit
Data
Setup
Squeegee
Change
Screen
Change
Tooling
Change
Language
Exit
The print carriage and the under screen cleaner are moved to the rear.
7. Select Full Width (F5).
Adjust Open
Cover
Home
Cleaner
Board
Stop
Full
Width
Load
Width
Print
Height
Exit
The message ‘Checking for a board on the belts’ is displayed. Whilst the rear
rail is moving the following message ‘Rail Moving...’ is displayed.
8. Select Open Cover (F2).
Adjust
Open
Cover
Home
Cleaner
Board
Stop
Board
Width
Load
Width
Print
Height
Exit
1.36 User Manual Software Version 6
MACHINE PROGRAMMING
STAGE 5B
9. Lift the front printhead cover.
10. The vacuum box can now be fitted into the appropriate location holes in the
tooling plate. Ensure the vacuum box is placed into the correct set of holes
taking regard of the type of screen being used. Connect the vacuum hose to
the vacuum box inlet, ensure the hose is routed clear of any moving parts.
11. Lower the front printhead cover.
Software Version 6 User Manual 1.37
MACHINE PROGRAMMING
STAGE 5B