Workcell-Installation-Guidelines-Troubleshooting-Maintenance-REV-F.pdf - 第7页
Workcell Installation and General Guidelines Revision F / Janu ary 2021 Page 7 of 59 Safety Certain warning symbols are aff ixed to the machine and corres pond to notations in this manual. Before operating t he system, i…
Workcell Installation and General Guidelines
Revision F / January 2021
Page 6 of 59
Introduction
Before you operate this system, read the operation and setup manual. This will help you to
become familiar with the product and ensure successful operation.
If any questions or problems arise, contact PVA’s Technical Support department.
PVA Contact Information
Main Office
Technical Support
PVA
Six Corporate Drive
Halfmoon, NY 12065
Tel +1-518-371-2684
Fax +1-518-371-2688
Website: http://www.pva.net
Email: info@pva.net
Tel +1-844-734-0209
Email: cs@pva.net
Document History
Revision
Revision Date
Reason for Changes
REV F
November 2020
Added Exhaust Requirements for DeltaTherm Humidity
REV E
October 2020
Combined Troubleshooting Maintenance Guide and
Spectra Install Info
REV D
December 2019
Exhaust Requirements and Shipping Bracket Info
REV C
November 2019
Marketing Rebrand
REV B
March 2019
Technical Support and Exhaust Updated
REV A
January 2015
Initial Release
Note: All photographs and CAD model representations in this document are a
“general representation” of the system and its components. The actual appearance
of the system and its components can differ based upon customer specific
configuration.
Workcell Installation and General Guidelines
Revision F / January 2021
Page 7 of 59
Safety
Certain warning symbols are affixed to the machine and correspond to notations in this
manual. Before operating the system, identify these warning labels and read the notices
described below. Not all labels may be used on any specific system.
Always wear approved safety glasses when you operate or work near the
workcell.
Before you operate the system, read and understand the manuals provided
with the unit.
Never put hands or tools in areas with this symbol when the machine is in
operation. A dangerous condition may exist.
Read and understand the manuals provided with the unit before any repairs
or maintenance is done. Only a qualified individual should do service.
Use caution when there are pressurized vessels. Find and repair any leaks
immediately. Always wear appropriate safety equipment when you work
with pressurized vessels or vessels that contain chemicals
Shear hazard from moving parts. Avoid contact.
Do not remove protective guarding.
In situations where inattention could cause either personal injury or damage
to equipment, a warning notice is used.
Workcell Installation and General Guidelines
Revision F / January 2021
Page 8 of 59
Do not smoke near the PVA UV cure machine. Always have a fire
extinguisher available for emergency use.
Before performing any repairs or maintenance to the system, turn off power
and lock out the power disconnect switch.
Warning notices are used to emphasize that hazardous voltages, current,
temperatures, or other conditions that could cause personal injury exist in
this equipment or may be associated with its use. Only qualified personnel
should enter areas designated with this symbol.
Laser light source present. Do not stare directly into the beam. Do not use in
the presence of highly reflective surfaces
Pinch hazard from moving parts. Avoid contact.
Hot surface. Avoid contact.
Warning, Ultraviolet (UV) light hazard. Do not look directly at the UV light
source.
This product meets EU standards for health, safety, and environmental
protection.
Warning, no open flames.
Electrostatic sensitive device warning. Observe precautions for handling.