03238396-01-01 High Flow Vacuum (TQ).pdf - 第44页

6 USER GUIDE 6.2 ERROR MESSAGES AND INDICATORS 44 STANDALONE MANUAL HIGH FLOW VACUUM (TQ) 12/2020 6.2 ERROR MESSAGES AND INDICATORS 6.2.1 Vacuum Error Handling Provided the High Flow Vacuum Check parameter (system Menu/S…

100%1 / 52
6 USER GUIDE
6.1 SETUP PROCEDURES
STANDALONE MANUAL HIGH FLOW VACUUM (TQ) 12/2020 43
33. Select Complete.
34. Select the Adjust tab.
35. Select Board Limit.
36. Set the board limit to 5.
37. Select Accept.
38. In the Information bar, the information posted is: Adjust Parameters Modified. Select Save.
39. Select the Status Tab. Provided the printer is ready to accept and print some test boards
(print medium/product available) the printer is ready for printing.
40. Select Print.
6.1.3 Machine Set Up
There are no user parameters in Machine Setup that relate specifically to High Flow Vacuum set
up. The vacuum can be switched ON or OFF in: Menu/Manage Printer Setup/Check Tooling.
6 USER GUIDE
6.2 ERROR MESSAGES AND INDICATORS
44 STANDALONE MANUAL HIGH FLOW VACUUM (TQ) 12/2020
6.2 ERROR MESSAGES AND INDICATORS
6.2.1 Vacuum Error Handling
Provided the High Flow Vacuum Check parameter (system Menu/Service/Machine Setup) has
been enabled the system reports on any vacuum problems.
On error, the user is presented with the following recovery options:
●
Retry- to repeat the vacuum check
●
Open Cover Commands: open the printhead cover- check for obstructions
●
Cancel-the print operation is stopped
●
Check the vacuum thresholds
6 USER GUIDE
6.3 DIAGNOSTICS
STANDALONE MANUAL HIGH FLOW VACUUM (TQ) 12/2020 45
6.3 DIAGNOSTICS
The diagnostic is accessed via:
1. On the HMI select Menu button.
2. Select Service.
3. Select Diagnostics.
4. Select Confirm.
The features of the page are:
– The status of the HFV Table Present (fitted or not fitted) is shown by indicator
– The status of the HFV Diverter Valve Actuated (Extended) is shown by indicator
– The status of the HFV Diverter Valve Retracted is shown by indicator
5. Select Table And Conveyor Lift.
The features of the page are:
– Switch Off HFV Pump - the system vacuum can be switched on or off
– Retract HFV Diverter valve – switches the valve to its retracted state
– The status of the HFV Table Present (fitted or not fitted) is shown by indicator
– The status of the HFV Diverter Valve Actuated (Extended) is shown by indicator
– The status of the HFV Diverter Valve Retracted is shown by indicator
– Cycle Tables. This switch cycles the table movements for several cycles as set in the
Number of Cycles parameter. The table lifts from Home to Print Height, pausing at Trans-
port Height and Vision Height
– Individual table height commands: Provides table movements to Print, Vision, Clamp,
Transport and Home heights
– Reset Axes Table command is reserved for Dual Table Mode
6. Select Exit.
7. Select Accept.