STM1-S_SDV_Maintenance(Eng_Ver1).pdf - 第59页
Mon thly Inspe ction Chap ter 5 Multi -Func tional Placer ST M1-S M ain ten an ce Ha nd bo ok 5-8 Cleaning and Lubricating X Frame LM Guide, Ball Screw Monthly Inspe ction T ool for M aintenanc e Ultra-fine fiber cloth, …
Monthly Inspection
Chapter 5
Multi-Functional Placer
STM1-S Maintenance Handbook
5-7
Cleaning and apply grease the Head LM Guide, Ball Spline
Tool for Maintenance
Ultra-fine fiber cloth, Flat Brush, GREASE: AFE-CA
Measures
Step 1.
Move the X Frame to front by referring to "Forward
movement of the X-frame" on page 1-3.
Step 2.
Press the 'STOP' and 'RESET' buttons in order after
pressing the 'EMG' button on the OP panel to stop
operation.
For more details, refer to "How to perform emergency stop" on page
1-2.
Step 3.
Clean the LM guide rail and mirror CAM and ball spline
using an ultra fine fiber cloth.
Step 4.
Apply grease to the LM guide rail and mirror CAM and
ball spline using a flat brush.
Grease application capacity for each spindle: 5 to 10g
Step 5.
Release the emergency stop as described in "Releasing
'Emergency Stop' mode" on page 1-6 and perform the
operation again.
Cleaning and apply grease the Head LM Guide, Ball
Spline
(Time required: 30min / No. M-5)
Monthly Inspection
Chapter 5
Multi-Functional Placer
STM1-S Maintenance Handbook
5-8
Cleaning and Lubricating X Frame LM Guide, Ball Screw
Monthly Inspection
Tool for Maintenance
Ultra-fine fiber cloth, Lubricator (Grease-Gun_Mg70_THK), Grease : AFE(THK)
Measures
Step 1.
Move the X Frame to front by referring to "Forward
movement of the X-frame" on page 1-3.
Step 2.
Press the 'STOP' and 'RESET' buttons in order after
pressing the 'EMG' button on the OP panel to stop
operation.
For more details, refer to "How to perform emergency stop" on page
1-2.
Cleaning and Lubricating X Frame LM Guide, Ball
Screw
Step 3.
Clean the LM guide rail and ball screw using an ultra fine
fiber cloth
(Time required: 60min / No. M-6)
Monthly Inspection
Chapter 5
Multi-Functional Placer
STM1-S Maintenance Handbook
5-9
Cleaning and Lubricating X Frame LM Guide, Ball Screw
Monthly Inspection
Step 4.
Lubricate the head 0.5 time at No.1 and No. 2 position,
respectively.
1
2
Caution
If the machine's operating environment is harsh, check its lubrication
status frequently.
The designated grease must be applied using the designated
lubricator in the designated manner. Other lubricating methods are
unacceptable.
Step 5.
.Move the head left and right 3 to 4 times to let the
grease applied all over the head