STM1-S_SDV_Maintenance(Eng_Ver1).pdf - 第65页
Mon thly Inspe ction Chap ter 5 Multi -Func tional Placer ST M1-S M ain ten an ce Ha nd bo ok 5-1 4 Cleaning and Lubricating the Y Frame Ball screw Monthly Inspe ction Step 4 . Move t he X Fra me to t he fro nt sid e and…
Monthly Inspection
Chapter 5
Multi-Functional Placer
STM1-S Maintenance Handbook
5-13
Cleaning and Lubricating the Y Frame Ball screw
Cleaning and Lubricating the Y Frame Ball screw
Tool for Maintenance
Ultra-fine fiber cloth, Lubricator (Grease-Gun_Mg70_THK), Grease :AFE (THK)
Measures
Step 1.
Move the X Frame to rear by referring to "Backward
movement of the X-frame" on page 1-4.
Step 2.
Press the 'STOP' and 'RESET' buttons in order after
pressing the 'EMG' button on the OP panel to stop
operation.
For more details, refer to "How to perform emergency stop" on page
1-2.
Step 3.
Clean the ball screw rail using an ultra fine fiber cloth.
(Time required: 20min / No. M-8)
Monthly Inspection
Chapter 5
Multi-Functional Placer
STM1-S Maintenance Handbook
5-14
Cleaning and Lubricating the Y Frame Ball screw
Monthly Inspection
Step 4.
Move the X Frame to the front side and apply grease on
the ball screw using a grease gun (0.5 time (apply a half
amount of grease))
Move the X Frame to the rear side and apply grease in
the same way as the front side
A
A
Caution
The designated grease must be applied using the designated
lubricator in the designated manner. Other lubricating methods are
unacceptable.
If the machine's operating environment is harsh, check its lubrication
status frequently.
Monthly Inspection
Chapter 5
Multi-Functional Placer
STM1-S Maintenance Handbook
5-15
Cleaning and Lubricating the Y Frame Ball screw
Monthly Inspection
Step 5.
Move the X frames back and forth three times.
Step 6.
Release the emergency stop as described in "Releasing
'Emergency Stop' mode" on page 1-6 and perform the
operation again.