00195044-22_UM_VisionTeachStation_5.x.x_DE_EN.pdf - 第121页
Vision Teach Station 5.x.x User Manual 5 Installing the cameras 05/2019 Edition 5.1 Installing stationary cameras, type 25, 33 and 36 29 5 Installing the cameras The vision teach station is supp lied with the ordered cam…
4 Setting up the vision teach station Vision Teach Station 5.x.x User Manual
4.4 Connecting the CAN bus between base module and PC 05/2019 Edition
28
Vision Teach Station 5.x.x User Manual 5 Installing the cameras
05/2019 Edition 5.1 Installing stationary cameras, type 25, 33 and 36
29
5 Installing the cameras
The vision teach station is supplied with the ordered camera fully installed. The following sections
describe how to install the stationary cameras and the head cameras.
5.1 Installing stationary cameras, type 25, 33 and 36
The type 25, 33 and 36 stationary cameras can be installed on the following placement machines:
Tab. 5.1 - 1 Stationary camera for the D and X-series
Installation of the stationary cameras is described with reference to camera type 33. Type 25 and
36 are installed in the same way. Only the coding switch settings are different.
WARNING 5
When you lift or carry the stationary camera, never hold it by the illumination head alone (item 1
in Fig. 5.1 - 1
, page 30). The latching connection between the illumination head (item 1) and the
base module (item 2) could be broken by the weight of the base module (item 3 in Fig. 5.1 - 1
,
page 30), causing the base module to fall off.
CAUTION 5
The plug-in illumination head (item 1 in Fig. 5.1 - 1
) incorporates the illumination section that is
matched to the camera's CCD sensor. You should therefore never swap the illumination heads
between cameras. If you do, the cameras will no longer work.
Component camera Placement machines
Type 25 (FC camera)
SX series, X-series, D1 and D3
Type 33 (IC camera)
SX series, X-series, D1 and D3
Type 36 (IC camera)
SX series, D1
5 Installing the cameras Vision Teach Station 5.x.x User Manual
5.1 Installing stationary cameras, type 25, 33 and 36 05/2019 Edition
30
5.1.1 Connecting cable set 03040355-xx to the camera
5.1.1.1 Opening the camera
Place the camera with the base plate (item 4) on a flat, clean surface.
Pull the illumination head (item 1) forward 30 mm or so.
Lift and remove the cover (item 2) from the base module (item 3).
The plug-in connectors and DIP switches are now accessible.
5
Fig. 5.1 - 1 Opening camera type 33
(1) Illumination head
(2) Cover
(3) Base module
(4) Base plate
5.1.1.2 Connecting the cables and checking the DIP switches
Connect connector X4 on the cable 03040355-W1 to connector X4 on the board. This supplies
the camera with power (see Fig. 5.1 - 2
, page 31).
Connect connector X10 on the cable 03040355-W2 to connector X10 on the board (CAN bus)
(see Fig. 5.1 - 2
, page 31).