00195044-22_UM_VisionTeachStation_5.x.x_DE_EN.pdf - 第141页
Vision Teach Station 5.x.x User Manual 6 2nd camera option 05/2019 Edition 6.1 Vision teach station upgrade 49 6 2nd camera option Y ou can install a second camera on the vision teach station as an option. W e can provid…
5 Installing the cameras Vision Teach Station 5.x.x User Manual
5.3 Installing the type 23 head camera 05/2019 Edition
48
Vision Teach Station 5.x.x User Manual 6 2nd camera option
05/2019 Edition 6.1 Vision teach station upgrade
49
6 2nd camera option
You can install a second camera on the vision teach station as an option. We can provide the
upgrade package you will need. This package does NOT include the camera and assembly kit,
however, which should be ordered separately.
6.1 Vision teach station upgrade
6.1.1 Bill of materials
6.1.2 Component camera
You will find the order data for the component cameras in section 3.2, page 15.
6.1.3 Assembly
When the vision teach station is converted to two cameras, the pillar and the component positio-
ning table are moved from the middle to the left (see Fig. 6.1 - 1
, page 51). The additional pillar
and the component positioning table are fixed to the holes on the right-hand side. The conversion
is described in the enclosed assembly instructions.
Order designation Item no.
Optional 2nd pillar for vision teach station
03063366-xx
Designation Item no. Number
Vision teach station pillar
03039431-xx 1
Cable set for vision teach station
03040352-xx 1
Assembly instructions "Optional pillar for vision teach
station" 00196052-xx 1
6 2nd camera option Vision Teach Station 5.x.x User Manual
6.1 Vision teach station upgrade 05/2019 Edition
50
6.1.4 Connecting two stationary cameras
If there is also a stationary camera (SST33, 36 or 25) used on the second pillar, the main power
supply and the CAN bus are plugged directly into the camera on the first pillar, rather than into the
base module. You will need cable kit 03040352 to do this.
First plug this cable kit into the second, additional camera following the instructions in section
5.1.1
, page 30.
Fit the camera onto the second pillar following the instructions in section 5.1.2, page 34.
Then connect the cable 03040352-W1 to connector X5 on the camera on pillar 1. Connector
X5 is difficult to access while the housing cover is fitted.
To access the connector, you should ideally put the vision teach station on the floor and remove
the dust cover (foam rubber) so that you can see in clearly from above. Connector X5 is be-
neath connector X4, or, as shown in Fig. 5.1 - 2
, page 31, to the right of X4. The connectors
X4 and X5 are interchangable.
Connect cable 03040352-W2 to connector X12 from cable kit 03040355 (see Fig. 5.1 - 2, page
31
, bottom left).