Operating Manual SIPLACE Multi-Docking Station.pdf - 第29页

25 SIPLACE Multi-Docking-St ation 4 Operation Operating Manual 4.2 Adjusting the T ransport Height 4.2.1 Adjusting the dimension Y 1. Remove th e side cov er . 2. Loosen the lock nuts on all adju sting feet. 3. Use the a…

4 Operation SIPLACE Multi-Docking-Station

4.2 Adjusting the Transport Height Operating Manual

4.1.1 CAN Bus Addresses

The CAN bus addresses that can be set are indicated on the sticker located below the switches

S1 and S2.

Fig. 4 - 2 CAN bus addresses

4.2 Adjusting the Transport Height

Flat spanners of size SW 22 and SW 24 and a spirit level are required.

Fig. 4 - 3 Adjusting the dimension Y

(1) 2x lock nut SW 24

(2) 1x adjusting screw SW 22

Detent pin

SIPLACE Multi-Docking-Station 4 Operation

Operating Manual 4.2 Adjusting the Transport Height

4.2.1 Adjusting the dimension Y

1. Remove the side cover.

2. Loosen the lock nuts on all adjusting feet.

3. Use the adjusting screws to adjust the dimension Y (see table).

4. Check that the machine is horizontal (using the spirit level).

5. Retighten the lock nuts.

6. Replace the side cover.

4.2.2 Setting the Transport Height

After the dimension Y has been adjusted to the specified value, the transport height can be

adjusted via a detent pin. There are three detent positions and transport height marks indicating

the selected transport height. The mechanical assembly is seated in gas pressure springs, which

facilitates its setting and prevents it from falling down by its own weight.

Fig. 4 - 4 Adjusting the transport height

1. Grab the power and data interface at a suitable position and pull the detent pin.

2. Push or lift the mechanical assembly in the appropriate direction to set the desired transport

height. T

ransport height marks are provided as guides.

3. Be sure to replace the detent pin in its proper position.

Machine height Dimension X Dimension Y Dimension Z

900 mm 854 mm

100 mm

770 mm

930 mm 884 mm 800 mm

950 mm 904 mm 820 mm

Detent pin

Lower transport

height mark

Upper transport

height mark

4 Operation SIPLACE Multi-Docking-Station

4.3 Docking and Undocking the Component Cart Operating Manual

4.3 Docking and Undocking the Component Cart

Fig. 4 - 5 SIPLACE Multi-Docking Station

(1) Pneumatic cylinder for locking the component cart

(2) Sensor for component cart detection

(3) Centring pin

4.3.1 Docking the SIPLACE SX Component Cart to the Multi-Docking Station

WARNING

Do not reach between the areas between the component cart and the SIPLACE Multi-Docking

Station during docking.

– Push the component cart into the docking station until it is locked by the pneumatic cylinders.

– The two buttons will flash shortly. If the component cart is properly locked, the w

hite button

(component cart release) will be lit permanently.

– If the component cart is not locked properly, the

white button will be flashing.

– If the feeders are locked properly, the green feeder

locking button will be lit.