00198171-02_Technical_Training_FSE_TX-Series_EN.pdf - 第22页
2 Machine Basic Overview 2.6 Configuration Help 22 Technical Training FSE SIPLACE TX-Series 01/2018 2.6 Configuration Help 2.7 Excercise: TX Machine Basic Overview 1. Which is the best answer regarding TX machine types? …
2 Machine Basic Overview
2.5 Special Features
Technical Training FSE SIPLACE TX-Series 01/2018 21
Feeder Count With C&P20 M2 With CPP M
Location 1 38 40
Location 2 38 40
TX 2i micron 15 µm Machine Configuration
Two gantries with same or different head
types possible:
●
C&P20 M2 / C&P20 M2 camera type 41
●
CPP M_L / CPP M_L camera type 45
●
Stiffened lifting table
●
Basic pack vacuumtooling and vacuumtool
with Y-fiducial bar
●
X-fiducial bar
●
No stationary cameras
Table Position:
Speed application
●
Location 1: Inner
●
Location 2: Inner
Feeder Count With C&P20 M2 With CPP M
Location 1 38 40
Location 2 38 40
2.5 Special Features
SIPLACE TX Thermal Management
Process exhaust air:
●
Warm air separated from processing area
●
Outlet of exhaust air in centralized position
●
Fans status monitored by software
TX micron Special Features
●
The TX micron machines will be equipped with two X fiducial bars parallel to the conveyor
close outside of the conveyor rails on the standard conveyor. On each location one specific
calibration jig holder and a separate zero point fiducial.
●
TX micron 15µm with the option “Basic pack vacuum tooling” and the license for 15µm / 3s
will be deliever with stiftness lifting table.
2 Machine Basic Overview
2.6 Configuration Help
22 Technical Training FSE SIPLACE TX-Series 01/2018
2.6 Configuration Help
2.7 Excercise: TX Machine Basic Overview
1. Which is the best answer regarding TX machine types?
A A two gantry is a possible configuration for TX machines, It is called TX2.
B A two gantry machine with inner table positions is a possible configuration for TX machines,
It is called TX2i.
C One gantry is a possible configuration for TX machines, It is called TX1.
2 Machine Basic Overview
2.7 Excercise: TX Machine Basic Overview
Technical Training FSE SIPLACE TX-Series 01/2018 23
D A, B and C configurations are all correct.
2. What is the correct answer?
A 80 pcs of 8 mm feeder can be setup on a TX machine with 2XCP20 P Head configuration.
B A stationary camera can be in installed at both locations for TX machine.
C The docking unit always in inner position in location 2 for TX machine.
D JTF-ML can be installed in location 2 for TX machine.
3. What option is not possible in a TX machine?
A Reject plate.
B Stationary camera for Twin Head or CPP in Location 1.
C Long Board option.
D Second fiber optic sensor for second board stop in placement area.
4. What are the differents between TX and TX micron machine?
A Differences are only in the machine specification.
B The TX micron has a more accurate specification and more accurate placement heads.
C The machines have different software versions.
D The TX micron does not support the TX shuttle.