00198171-02_Technical_Training_FSE_TX-Series_EN.pdf - 第62页
5 Component Supply Room for Your Sketches and Notes 62 Technical Training FSE SIPLACE TX-Series 01/2018
5 Component Supply
Room for Your Sketches and Notes
Technical Training FSE SIPLACE TX-Series 01/2018 61
5 Component Supply
Room for Your Sketches and Notes
62 Technical Training FSE SIPLACE TX-Series 01/2018
6 Conveyor System
6.1 Main Overview
Technical Training FSE SIPLACE TX-Series 01/2018 63
6 Conveyor System
6.1 Main Overview
Main Overview TX
●
As standard, the TX machines are set up with dual conveyors and fixed conveyor on the outer
rail. The fixed conveyor left or right side is available as an option.
●
The whole conveyor consists of one part with input (410 mm), placement (PA, 380 mm) and
output (210 mm) sections.
●
The conveyor supports asynchronous and synchronous dual lane mode and I-Placement
mode
●
The conveyor supports the following heights: 900, 930 and 950 mm, standard height is 930
mm.
●
Communication between the PCB conveyors is provided with SMEMA or (optionally)
SIEMENS interface.
●
Input and output conveyor extensions (for barcode scanner, JTF-ML feeder).
1. Transport control board (box)
2. Transport drives
3. Width adjustment motor
4. Lifting table (below lifting motor)
5. Output section (219mm)
6. Placement Area (380mm)
7. Input section (410mm)
T. Transport direction
Conveyor Modes
1. Dual conveyor as single
mode (License required)
2. Synchronous mode op-
tional second sensor in PA
3. Asynchronous mode
with optional second
sensor in PA
NOTICE
If the length of boards is shorter than 175mm, an additional optional light barrier sensor can
be installed for the "Convoy Mode".
Main Overview TX micron
In order to ensure the required accuracy the TX micron conveyor system is slightly different to the
standard TX machine.