JO-109-002_JG-0209.pdf - 第172页
5-3 JO-109 2. Others 1005-001 2. Others • Shape of Connector D-Sub 15 Pins (Socket T ype) • Contents of Signals and Pin Nos. T able E1 Pin Nos. I/O Contents of Signals Remarks 1 POW Output +24V -1 +24V through Relay 2 PO…
5-2
JO-109
1. Troubleshooting against Main Errors
1005-001
(3) Feeder Action Command Timeout
Error Message
: No response is made to the feeder send command.
Check the cable connection.
Cause
: 1. No connection is made with feeder.
2. There is abnormality in the DIO equipment.
Remedy
: 1. Conrm that power is supplied to the feeder.
2. Connect the inspection device and the personal
computer.
(4) Feeder Clamp Release Error
Error Message
: The clamp was released during the measurement.
Remove the cause of the error and check the clamp
condition. After that, perform the measurement
again.
Cause
: The feeder clamp was released during the inspection.
Remedy
: Check the clamp condition and perform the
measurement again.
When the same error is still displayed, check and adjust
the switch located under the clamp.
(5) Feeder Power Supply Error
Error Message
: The power to the feeder was cut off during the
measurement.
Remove the cause of the error and check the
connection of the feeder. After that, perform the
measurement again.
Cause
: The power to the feeder was cut off during the
measurement.
Remedy
: Check how the feeder is installed and perform the
measurement again.
5-3
JO-109
2. Others
1005-001
2. Others
•
Shape of Connector
D-Sub 15 Pins (Socket Type)
•
Contents of Signals and Pin Nos.
Table E1
Pin
Nos.
I/O Contents of Signals Remarks
1 POW Output +24V-1 +24V through Relay
2 POW Output +24V-1 +24V through Relay
3 POW GND-1 GND through Relay
4 POW GND-1 GND through Relay
5 POW Output +24V Clamp Switch
6 Input Feeder Clamp Switch Clamping at Short Circuit
7 Output Feeder Send Signal Lane #1 ON at Short Circuit
8 Output Feeder Send Signal Lane #2 ON at Short Circuit
9 Input Feeder Action Complete Signal Action Complete at Short Circuit
10 Input Feeder Connection Check Signal 1 Connected at Short Circuit
11 Input Feeder Connection Check Signal 2 Connected at Short Circuit
12 - Reserved
13 RS-TXD RS232C Communication TXD RS232C Communication
14 RS-RXD RS232C Communication RXD RS232C Communication
15 RS-GND RS232C Communication GXD RS232C Communication
Note
"Input" and "Output" are the signal directions viewed from the control
section.
5-4
JO-109
3. Layout
1106-002
3. Layout
3.1 Electrical Box
Z01 Noise Filter
G01 DC Power Supply
K01 Relay
K02 Relay
Q01 Breaker
H01
Power Supply Lamp
G02
For Measured Data Transfer Unit
Note
The jig in the above inset photo might look different from the actual one.