00196504-02_UM_X-Serie_SR70X_EN.pdf - 第281页
User manual SIPLACE X-series Setting up and commissioning From software version SR.70x.xx 01/2011 EN edition Setting up the machine 281 → Make sure that you do not unscrew the middle mach ine feet so far that the ma chin…
Setting up and commissioning User manual SIPLACE X-series
Setting up the machine From software version SR.70x.xx 01/2011 EN edition
280
4
Fig. 4.3 - 32 Setting the height for the outer machine feet
(1) Adjusting screw M24x2x120 to adjust the height
(2) Outer machine foot
(3) Clamp
(4) M24x90 hexagon socket head screw
→ Check the required PCB conveyor height.
→ If the machine has been aligned, use the torque wrench to tighten the hexagon socket head
screws M24x90 (item 4) for holding the clamps on all the outer machine feet (item 3).
PLEASE NOTE 4
The tightening torque is 130 Nm. The machine may tend to vibrate if a lower tightening torque
is used.
→ Unscrew the middle machine feet using a hook wrench 135 - 145 until they are seated firmly
on the ground.
User manual SIPLACE X-series Setting up and commissioning
From software version SR.70x.xx 01/2011 EN edition Setting up the machine
281
→ Make sure that you do not unscrew the middle machine feet so far that the machine is no lon-
ger adjusted.
4
Fig. 4.3 - 33 Aligning and locking the middle machine foot
→ Use the spirit level to ensure that the machine is precisely aligned.
→ Use the size 65 open-ended spanner to tighten the M24 lock nut (item 3).
4.3.19 Removing the shipping braces
– Remove all the shipping braces from the gantry axes.
(1) Spacer
(2) Middle machine foot
(3) M24 lock nut
Setting up and commissioning User manual SIPLACE X-series
Setting up the machine From software version SR.70x.xx 01/2011 EN edition
282
4.3.20 Removing the corrosion protection from the guide rails
The machines were given a corrosion protection treatment before they were delivered.
CAUTION 4
– You should therefore remove the corrosion protection from all the axes and bearings when
you traverse the machine axes for the first time during commissioning.
– Grease all the axes and bearings with the grease described in the maintenance instructions.
If the corrosion protection agent is mixed with the bearing grease on the axes this can greatly re-
duce the service life of the bearings and guide rails.
CAUTION 4
Do not allow any alcohol to enter the guide carriages when you clean the guide rails and scale
rods. Alcohol will damage the bearing grease in the guide carriages.