00196932-02 SM S-Feeder Repair DE+EN multilang.pdf - 第114页
7 3x8mm S-Feeder checking and adjusting worm ge ar 7.2 3x8mmS: Adjusting cur rent input via the worm play 114 SIPLACE S-Feeder Repair SIPLACE S-Förderer Reparatur Prior to remove the worm gear: ▪ Switch the tester OFF (P…
7 3x8mm S-Feeder checking and adjusting worm gear
7.2 3x8mmS: Adjusting current input via the worm play
SIPLACE S-Feeder Repair SIPLACE S-Förderer Reparatur 113
9. Turn ON the left track of the tester-> Switch 6/30V in
Position 6V and switch 1 under "tape drive" up.The switch
position 30V is suitable for endurance test.
10. Turn the knurled screw of the left track until the rated
current input of 60 - 120mA (11) has been reached.
11. .During one complete revolution of the index wheel,
the current consumption should be constant!
12. Keep the motor running AND in this position, fasten
the two Allen screws M3 (size 2.5) of the adjusted track
hand-tight . With the screws tightened, the tester must
continue indicating 60 - 120mA (11).
13. Check the motor running noise for constancy.
14. Turn the left track on the tester OFF (switch 1 down).
15. Finally check the clearance of the adjusted track: For
this purpose, press your finger gently touching against
one pin of the sprocket wheel´s the track and try turning it:
▪ There must be NOT ANY perceptible clearance in
both directions of rotation any longer.
▪ Otherwise repeat the adjustment process.
▪ The drive assembly has to be repaired if adjustment
should not be optimally possible.
16. Now perform testing and adjusting the middle track
(Switch 2 under "tape drive"). For this purpose, proceed
according to the description for the left track..
17. Now perform testing and adjusting the right track.
(Switch 3 under "tape drive"). For this purpose, proceed
according to the description for the left track.
This completes the adjustment and the drive can be re
-
moved.
7 3x8mm S-Feeder checking and adjusting worm gear
7.2 3x8mmS: Adjusting current input via the worm play
114 SIPLACE S-Feeder Repair SIPLACE S-Förderer Reparatur
Prior to remove the worm gear:
▪ Switch the tester OFF (Power OFF).
▪ Then remove the 3 plugs from the connection box.
1. By now swing the lever (black handle) upward.
2. Fold the track-adjusting jig downward.
3. Remove the worm gear drive.
4. Now close the jig again. Testing is completed.
8 2x8mm S-Feeder checking and replace worm gear
8.1 Removing Sprocket Wheel / Worm Gear
SIPLACE S-Feeder Repair SIPLACE S-Förderer Reparatur 115
8
8 2x8mm S-Feeder checking and replace worm gear
2x8mm S-Feeder checking and replace worm gear
8.1
8.1 Removing Sprocket Wheel / Worm Gear
Removing Sprocket Wheel / Worm Gear
Remove the M2.5 screw on base of the respective front
track at location
1. On the front under site of the feeder.
2. From the top in the middle of the base plate.
3. Remove six countersunk screws on each side of the
track.
4. Remove the pickup window.
5. Remove the protection ring.