NR_Mechanischer_Stopper.pdf - 第206页

Assembly Instructions PCB Stopper Sin gle Conveyor SIPLACE S-27HM / HS-60 / D4 / D3 / HF- / X-Series Edition 06/2007 206 O For a single conveyor , stick the dist ance block on to the position of co nveyor track 1. The st…

100%1 / 238
Assembly Instructions PCB Stopper Single Conveyor SIPLACE S-27HM / HS-60 / D4 / D3 / HF- / X-Series
Edition 06/2007
205
O Attach the guide strip to the holders with two cylinder head bolts (hexagon socket head
M5 x 20 DIN 912).
O Test whether the trailing cable can move freely by pushing it to the end from the side.
O For the HF-/X-Series (mounting tub 604 mm) with dual and single conveyor, the following dis-
tances must be observed:
Fig. 185 Distances for the trailing cable distance blocks (HF, X-Series)
For a dual conveyor, stick an additional "Distance block for energy chain, complete" in the mid-
dle between the two energy chain distance blocks for better movement of the trailing cable.
[03043432-xx]. 15
O Using the adhesive tape, stick the distance block of the trailing cable onto the mounting tub
under the second conveyor side parallel to the guide rail (or to the width adjustment) in such a
way that the trailing cable stands vertical when the guide rail is installed.
Conveyor track 2 Conveyor track 1
Distance block for energy chain
Left
conveyor side
Right
conveyor side
340 mm 260 mm
440 mm
160 mm
Transport direction
Left side of
mounting tub
Right side of
mounting tub
604 mm
Assembly Instructions PCB Stopper Single Conveyor SIPLACE S-27HM / HS-60 / D4 / D3 / HF- / X-Series
Edition 06/2007
206
O For a single conveyor, stick the distance block onto the position of conveyor track 1. The stop-
per must be able to slide over the entire conveyor width. The distance block stuck on the floor
of the mounting tub must be positioned so that the trailing cables run parallel to the guide strip
of the stopper. If other cables prevent this, they must be repositioned.
Fig. 186
15
Caution, crash hazard:
– It is essential to ensure that the stopper and the trailing cables do not collide with the width
adjustment or its conveyor belt.
– The stoppers must be able to slide over the entire conveyor width.
– The trailing cable of conveyor track 1 must run exactly on the trailing cable of the stopper in
conveyor track 2 and must not tilt to the side.
– The distance between the two distance blocks should be approx. 100 mm.
– The laying of cables and tubing are described in a later section for functional reasons.
Assembly Instructions PCB Stopper Single Conveyor SIPLACE S-27HM / HS-60 / D4 / D3 / HF- / X-Series
Edition 06/2007
207
15.3 Installation at placement area 2
Caution: Before the stopper is mounted in the machine, it should be adjusted with the guide strip
and the shims. Care should be taken to ensure that the stopper is not too loose or too tight. The
graduation of the shims is 0.1mm.
(See also Fig. 209, page - 232.)
15.3.1 Installation of the holders
O Install the "Guide strip holders PA2 HF" [03032320-xx] for the guide strip of the PCB stopper.
The holders are installed so that they are flush at the top with the lateral frames of the lifting
table. To prevent the holder from twisting, the lateral shoulder of the holder must lie against the
outside of the frames.
Fasten each of the holders with a cylinder head bolt with hexagon socket head
M4 x 40-DIN 912.
Fig. 187 Holders
Holders