00198001-02_IM_709.1_DE_EN.pdf - 第48页
Station Software 709.1 / Installation Manual Ausgabe 05/2016 E dition 48 7.2 X- Series S Placem ent Machines ► When the X - S eries S placement m achines are boot ed for the first time you have to select the CAN card (tw…
Station Software 709.1 / Installation Manual Ausgabe 05/2016 Edition
47
7.1 X-Series Placement Machines
The following window is displayed for the X-series machines. Here you can edit, confirm or reject
the Auto-configuration.
Figure 7-5: Confirming Auto-configuration for X-series
► Click the Confirm changes and continue startup button to confirm the Auto-configuration.
► If the Coplan computer has been installed, you will additionally have to confirm or reject the 3D
Coplan sensor.
Station Software 709.1 / Installation Manual Ausgabe 05/2016 Edition
48
7.2 X-Series S Placement Machines
► When the X-Series S placement machines are booted for the first time you have to select the
CAN card (two or four CAN buses):
Figure 7-6: Select CAN card for X-Series S
7.2.1 X4i S Placement Machine
► When the X4i S placement machine is booted for the first time you have to select the following
options manually:
– If a TrayStak Feeder is used, this has to be defined for each location concerned in the
Auto-configuration.
– Table position (inner and outer)
Station Software 709.1 / Installation Manual Ausgabe 05/2016 Edition
49
7.3 SX1/SX2 (V2) Placement Machine
For the SX1/SX2 (V2) placement machine the following window is displayed, in which the Manual
selection required note informs, that the table configuration has to be selected manually, as this is
not detected automatically.
Figure 7-7: Selecting table configuration
► Click the ? question mark next to Location 2.
The selectable table configurations are displayed.
Figure 7-8: Possible table configurations