00197551-01_MM_CPP-CP-Twin_Kunde_en.pdf - 第37页
Maintenance Tasks for C&P20/A/M/P Head Differences Between C&P20, C&P20 A, C&P20 M and C&P20 P Maintenance Manual SIPLACE Placement Heads CPP, C &P20, Twin 37 Fan The housing of the C&P20 P fe…
Maintenance Tasks for C&P20/A/M/P Head
Differences Between C&P20, C&P20 A, C&P20 M and C&P20 P
36 Maintenance Manual SIPLACE Placement Heads CPP, C&P20, Twin
4.1
4.1 Differences Between C&P20, C&P20 A, C&P20 M and C&P20 P
Differences Between C&P20, C&P20 A, C&P20 M and C&P20 P
CP20 Differenti ation
Differentiation of the C&P20 head variants
The C&P20/A/M and the C&P20 P head differ in many details. They are easily identified by the following
features:
1. The C&P20 P can be identified by the fan. This fan is not present on the C&P20/A/M heads.
2. The component sensor is flatter and wider on the C&P20 P than on the C&P20/A/M.
CAUTION
Do not confuse the different C&P20 head variants.
► Parts from the C&P20/A/M head can not usually be used for the C&P20 P head (and vice
versa)!
Maintenance Tasks for C&P20/A/M/P Head
Differences Between C&P20, C&P20 A, C&P20 M and C&P20 P
Maintenance Manual SIPLACE Placement Heads CPP, C&P20, Twin 37
Fan
The housing of the C&P20 P features an additional
fan (1).
This fan is not present on the C&P20/A/M.
Type
The C&P20A housing has a label with the head type on
it (1).
The other C&P20 variants do not have this label.
Linear guidance Z axis
The C&P20A/M/P has a blue dot on the Z axis rotor (1).
If the blue dot is missing, the type is C&P20.
Maintenance Tasks for C&P20/A/M/P Head
Maintenance Intervals
38 Maintenance Manual SIPLACE Placement Heads CPP, C&P20, Twin
4.2
4.2 Maintenance Intervals
Maintenance Intervals
5205 - Major - C&P20-A-M-P
9000 – Foot not e * Maintenanc e display
* see also maintenance display
Driver bearing
Heads with a black dot on the driver bearings (1) are
C&P20A/M/P heads.
The black dot is missing on C&P20 heads.
CAUTION!
The two versions need different oils.
Maintenance tasks
Speedstar C&P20/A/M/P
Duration
[min]
Each
week
Every 3
months
Every 6
months
Every 12
months
Preparing the Placement Head 5 X*
Replacing the Pressure Control Valve 3 X*
Cleaning the Z Axis 6 X*
Oiling the DP Segment Guide 15 X*
Oiling the Z Axis Linear Guide 3 X*
Oiling the DP Driver Bearing 4 X*
Checking/Replacing the Vacuum-Conducting
Parts
▪ Reflecting ring and cover
or
▪ Holding circuit and silencer
5X*
Cleaning the Raceway and the Jaw 2 X*
Replacing the Filter Disks 15 X*
Checking/Cleaning/Replacing the Switching Disks 1 x X*
Cleaning the Component Sensor 1 X*