00197551-01_MM_CPP-CP-Twin_Kunde_en.pdf - 第47页
Maintenance Tasks for C&P20/A/M/P Head 4.6.3 Oiling the DP Segment Guide Performing Maintenance Tasks Maintenance Manual SIPLACE Placement Heads CPP, C &P20, Twin 47 4.6.3 4 . 6 . 3 O ilin g t h e D P S e g m e n…
Maintenance Tasks for C&P20/A/M/P Head
Performing Maintenance Tasks 4.6.2 Cleaning the Z Axis
46 Maintenance Manual SIPLACE Placement Heads CPP, C&P20, Twin
Installing the Cover Plate
Select the applicable version for the head type:
Cover plate Z axis C&P20/A/M
► C&P20/A/M:
Fit the cover plate (1). Screw in and tighten the
screws at (2) until hand-tight and then tighten the
screw(s) at (3) with a torque of 130 Ncm.
For details, refer to the service manual.
Cover plate Z axis C&P20 P
► C&P20 P:
Fit the cover plate (1). Screw in and tighten the
screws at (2) and (3) until hand-tight.
For details, refer to the service manual.
Maintenance Tasks for C&P20/A/M/P Head
4.6.3 Oiling the DP Segment Guide Performing Maintenance Tasks
Maintenance Manual SIPLACE Placement Heads CPP, C&P20, Twin 47
4.6.3
4.6.3 Oiling the DP Segment Guide
Oiling the DP Segment Guide
► For this maintenance task, use the blue combitip with Thermoplex ALN 1001/00.
► Set the multipette to 2 µl.
► Rotate the head so that the segments are at the top.
► Clamp the rubber hose (1) between the Z axis and
the driver of the return unit.
► Rotate segment 1 in the center of the service open-
ing. Mark the first segment by removing a nozzle.
► Move the segment on the Z axis rotor out as far as the
end stop. Make sure that the driver bearing is in the
center of the jaws.
► Use a cleaning stick to clean the segment guide rail
on both sides.
Maintenance Tasks for C&P20/A/M/P Head
Performing Maintenance Tasks 4.6.3 Oiling the DP Segment Guide
48 Maintenance Manual SIPLACE Placement Heads CPP, C&P20, Twin
► Move the segment on the Z axis rotor out as far as the end stop. Make sure that the driver bearing
is in the center of the jaws.
► Apply another 2 µl of lubricant to each guideway and move the segment again approx. five times.
A total of 4 µl must be applied to each guideway.
► Move the Z axis upwards again.
► Make sure that the driver bearing is in the center of the jaws.
► Turn the star on to the next segment.
► Repeat this maintenance task for all segments.
► Fit the removed nozzle back into place.
► Apply 2 µl of lubricant to the center of each guide
track (left and right side).
► Move the segment on the Z axis rotor manually out as
far as the end stop and back in approx. five times.
► Remove excess oil from the top of the segment guide
rail, using a cleaning stick.