OM-1241-005_w.pdf - 第140页
4-13 AIX-ML T-ID 3.3 Inspection, Cleaning, and Lubrication Spots 0705-003 3.3.3 T raverse Bolt Linear Guide Every 3 Months Lubrication (DAPHNE EPONEX GREASE No. 1) Required T ime: 5 minutes W ipe off old grease with an o…
4-12
AIX-MLT-ID
3.3 Inspection, Cleaning, and Lubrication Spots
0705-003
Linear Guide
Every 3 Months Lubrication
(DAPHNE EPONEX GREASE No. 1)
Required Time: 5 minutes
Wipe off old grease with an oiled rag and
apply new one with a brush or supply
grease from eight grease nipples with a
grease gun.
Take ample care not to leave any
waste threads after cleaning.
Notice
Belt
Every 3 Months Inspection
Required Time: 1 minute
Visually inspect the wear of the belt.
Fig. D6
4-13
AIX-MLT-ID
3.3 Inspection, Cleaning, and Lubrication Spots
0705-003
3.3.3 Traverse
Bolt
Linear Guide
Every 3 Months Lubrication
(DAPHNE EPONEX GREASE No. 1)
Required Time: 5 minutes
Wipe off old grease with an oiled rag and apply new one
to the grooves of the linear guide with a syringe.
Take ample care not to leave any waste threads
after cleaning.
Pallet Receiver
Every 3 Months Inspection
Required Time: 1 minute
Visually inspect the wear of the pallet
receiver.
When the receiver is worn out to the extent
that the pallet is warped, follow the steps
below for the replacement.
1. Remove five bolts (one on side)
fastening the pallet receiver and detach
the receiver.
2. Attach a new pallet receiver and tighten
the bolts.
Note
No. 18
Use No. 18 (green) nozzle.
Notice
Fig. D7
4-14
AIX-MLT-ID
3.3 Inspection, Cleaning, and Lubrication Spots
0705-003
Pallet Chuck
Every 3 Months Lubrication
(DAPHNE EPONEX GREASE No. 1)
Required Time: 5 minutes
Wipe off old grease with an oiled rag and apply new one
to the grooves of the linear guide rails with a hand.
Take ample care not to leave any waste
threads after cleaning.
Notice
Fig. D8