OM-1058-002.pdf - 第12页
Tg0409-PM-SO If a thin tape is being used in TF-1210, the tape might come away from the chute section. If so, mount the attached auxiliary chute onto the chute section. Attach and store the chute not to be used into the …
Tg0409-PM-SO0410-002 10
2.1 Attachment of Tapes
Fig. 9 Foreign Substance on the Chute
(5) Make sure there is no foreign substance
sticking on the chute section or the rear
side of the suppressor.
If dirty, clean it.
If there is any foreign substance (such as chip component or
dust) on the chute and rear surface of the suppressor when the
tape is attached, then it might cause a suppressor distortion or
pick-up error.
Refer to "5.3.2 Maintenance in Tape Attachment and Product Change"
for details of cleaning.
Reference
Chip Component
Chip Component
Notice
Fig. 10 Foreign Substance on the Rear
Surface of the Suppressor
Tg0409-PM-SO
If a thin tape is being used in TF-1210, the
tape might come away from the chute
section. If so, mount the attached auxiliary
chute onto the chute section. Attach and
store the chute not to be used into the
housing tap, using set screws in order not
to lose. (Refer to Fig. 13).
If the set screws are fastened with
excessive torque in attaching to the
auxiliary chute, the screw sections
might become damaged.
Refer to "8.3 Specifications of 12 mm
Tape Feeder (For Embossed Tape) " for
Specifications of Tape.
0410-002 11
Fig. 11
Fig. 13 Housing Tap General View
(6) Lift the suppressor and then pass the
tape taken from the reel through the
suppressor.
Do not allow excessive loads on the
upper section when lifting the suppres-
sor, because the suppressor might
become deformed.
2.1 Attachment of Tapes
Tape
4
2
1
Auxiliary Chute
View
Fig. 12 Auxiliary Chute Attachment Position
General View
Notice
Notice
Reference
Note
TOP TAPE
MADE
IN
JAPAN
4
4
,
8
4
8
1
2
,
2
1
غغغغ-٤٤٤٤٤٤
Tape Feeder of TF-1610
Tg0409-PM-SO0410-002 12
2.1 Attachment of Tapes
Suppressor Stopper Pin
If a thin tape of less than 0.3 mm thickness
is used in a tape feeder of 16 mm width (TF-
1610), then replace the standard suppressor
stopper pin with the attached suppressor
stopper pin for thin tapes. Attach and store
the unused suppressor stopper pin into the
housing tap in order not to lose it.
If any tape feeding error or pick-up error
occurs, replace it with a standard suppressor
stopper pin.
Table 2
Standard
For Thin Tape
Diameter
φ 4.1 mm
φ 3.5 mm
Fig. 14
Fig. 15
Note
Suppressor Stopper Pin Housing Tap
غغغغ-٤٤٤٤٤٤
TOP TAPE
MADE
IN
JAPAN
8
1
2
6
1
8
1
2
,
1
6
,
2
1
6
1
4
4
4
8
,
Tape Feeder of TF-1610