OM-1058-002.pdf - 第15页

Tg0409-PM-SO 0410-002 14 Fig. 18 (8) Set the carrier tape so that the sprocket pins are securely engaged with the sprocket holes. (a) Make sure there is no foreign substance on the carrier tape. If there is any , remove …

Tg0409-PM-SO

(7) Pass the cover tape through the cover

tape hole and then pass it through the

slit on the tape peeling section.

Make sure that there is no foreign substance

on the tape peeling section on the shutter

assembly. If there is any, clean it.

Also make sure that there is no dust or fiber

on the cover tape.

If there is any, remove it with a rag or air

gun.

Refer to "5.3.2 Maintenance in Tape Attach-

ment and Product Change", for cleaning the

tape peeling section on the shutter assembly.

Clean the tape peeling section on the

shutter assembly.

If any foreign substance (component or

dust) is on the tape peeling section

when the cover tape is attached, it might

cause a component deformation or pick-

up error.

Reference

0410-002 13

2.1 Attachment of Tapes

Cover Tape Hole

Slit

Fig. 16

Fig. 17

Notice

Note

Tg0409-PM-SO0410-002 14

Fig. 18

(8) Set the carrier tape so that the sprocket

pins are securely engaged with the

sprocket holes.

(a) Make sure there is no foreign substance

on the carrier tape.

If there is any, remove it with a rag or

air gun.

(b) For tape feeder of 32 or 44 mm width,

attach the tape, aligning it with the pins

on the sprockets on the right and left.

(Refer to Fig. 19).

2.1 Attachment of Tapes

If any foreign substance (chip component, dust, debris or fiber) is

left on the carrier tape then a pick-up error might be caused.

Fig. 19 Tape Feeder of 32 or 44 mm Width

Notice

Note

Tg0409-PM-SO0410-002 15

2.1 Attachment of Tapes

Fig. 21

If the cover tape or the chip component gets caught by the

suppressor, then the peeling section might be deformed or a pick-

up error occur.

If there is any such catching of the cover tape or chip component,

do not pull it out forcibly; just lift the suppressor.

(10) Make sure that the cover tape or chip

component is not caught in the peeling

section.

If operation is performed with the

cover tape caught in the

suppressor . . .

It might also cause distortion in the tape

peeling section, or scratches on the cover

tape, which might lead to the tape's being

cut off.

The peeling section might be

deformed.

Suppressor

If the suppressor is lowered with

any foreign substance on the tape

surface . . .

Foreign Substance

Deformation

Cover Tape

Notice

(9) Lower the suppressor carefully.

When the suppressor for the tape feeder

with a tape width of 12 mm or more is to

be set, if such suppressor is forced into

setting while the pin is not aligned with

the U-groove, the suppressor might be

deformed.

Always set the suppressor while the pin

is aligned with the U-groove.

Notice

U-GroovePin

Fig. 20