OM-1058-002.pdf - 第29页
Tg0409-PM-SO 0410-002 28 ( 3 ) Push the locate lever in the direction shown by the arrow in the figure and set the locate pin on the feeder carriage. A force of about 19 to 25 N (2 to 2.5 kgf) is required to release the …
Tg0409-PM-SO
Notice
Fig. 44
• When the tape feeder is set, if the
front hook section is separated be-
cause of interference with the adjacent
feeder, it might cause breakdown of
the vacuum nozzle or machine. Make
sure that the front hook is securely
engaged with the pin.
• If the front hook section at the end of
the tape feeder is bumped, it might
cause deformation and pick-up error,
because the suppressor holding load
is not given enough allowance.
Take the greatest care not to bump the
front hook section.
Bend Section
Fig. 45 Bend Section (Photo of TF-1210)
• Do not hit against an adjoining tape
feeder. Specially, 12 mm or more width
tape feeder needs an attention to
avoid deformation because there is a
bend in the shutter.
0410-002 27
3.2 Tape Feeder Attachment Procedure
Tg0409-PM-SO0410-002 28
(3) Push the locate lever in the direction
shown by the arrow in the figure and set
the locate pin on the feeder carriage.
A force of about 19 to 25 N (2 to 2.5 kgf) is
required to release the locate lever.
Fig. 46
3.2 Tape Feeder Attachment Procedure
(4) Make sure there is no backlash on the lo-
cate lever and that the tape feeder is fixed
securely.
When the tape feeder is mounted onto the
feeder carriage, lightly pull the locate lever in
the direction shown by the arrow in the fig-
ure.
Fig. 47
(5) After mounting the tape feeder, hold the
grip and lightly move it right and left to
make sure it is locked.
Fig. 48
Locate Lever
19 to 25 N
19 to 25 N
(2 to 2.5 kgf)
(2 to 2.5 kgf)
19 to 25 N
(2 to 2.5 kgf)
Locate Lever
9.8 N
9.8 N
(1 kgf)
(1 kgf)
9.8 N
(1 kgf)
Tg0409-PM-SO
Notice
0410-002 29
Unused tape feeders should be removed from the feeder car-
riage. If a tape feeder is set onto the feeder carriage and not used
for a long time during the machine operation, slack will occurs in
the tape, which might cause pick-up error.
3.2 Tape Feeder Attachment Procedure
If the machine is used with the tape feeder lifted,
it might cause machine breakdown or pick-up
error.
Mount the tape feeder securely on the feeder
carriage.
CAUTION