OM-1058-002.pdf - 第36页

Tg0409-PM-SO 0410-002 35 5.2.3 Preparation for Lubrication Prepare specified grease and greasing tools. • Specified Grease Refer to "(1) Grease". Before lubrication, wipe off the old grease. Otherwise, the ef f…

Tg0409-PM-SO0410-002 34

5. Periodical Maintenance

5.1 Precautions before Maintenance

This describes the check, cleaning, and adjustment for tape feeders operating

in good conditions.

A full and periodical maintenance of the tape feeder is recommended.

5. Periodical Maintenance

5.2 Preparation for Maintenance

5.2.1 Preparation for Cleaning

• Rag

Use a rag made of such material (cotton, etc.) that produces

as less waste thread as possible.

A clean rag must be used depending on a spot to be cleaned.

• Air Gun

Do not use an air gun on unspecified locations.

• Brush

Use a normal brush on the market.

• Cotton Swab

Use a normal cotton swab on the market.

• Tweezers

Use normal tweezers on the market.

• Toothbrush

Use a normal toothbrush on the market.

• Alcohol

Do not use alcohol on unspecified locations.

5.2.2 Feeder Adjusting Jig

• Use the feeder adjusting jig JG-0148 (option).

Only trained persons should perform mainte-

nance, both carefully and according to the speci-

fied procedures.

CAUTION

Tg0409-PM-SO0410-002 35

5.2.3 Preparation for Lubrication

Prepare specified grease and greasing tools.

• Specified Grease

Refer to "(1) Grease".

Before lubrication, wipe off the old grease.

Otherwise, the effect of grease will decrease.

• Specified greasing tools

Refer to "(2) Thin Bar".

(1) Grease

• DAPHNE EPONEX GREASE No. 1 (IDEMITSU KOSAN)

• NEW MOLYNOC GREASE No. 1 (Nippon Oil Corporation)

Same Type of Lubricants

• DAPHNE EPONEX GREASE No. 1 (IDEMITSU KOSAN) or its

equivalent

5.2 Preparation for Maintenance

Table 4

(2) Thin Bar

It is required for lubrication in narrow space. Prepare a bar with a

diameter of 1 mm.

Do not use a bar with a rough nap like a cotton swab.

• NEW MOLYNOC GREASE No. 1 (Nippon Oil Corporation) or its

equivalent

Table 5

Notice

Tg0409-PM-SO

5.3 Maintenance Method

5.3.1 Description of Maintenance in Each Section

Here the maintenance cycle for each section of the tape feeder.

The described procedure takes for example a tape feeder of 8 mm width

(except for TF-0814).

This applies to most tape feeders, except for those given special descrip-

tions.

How to Locate the Check, Cleaning, Lubrication and Adjustment

Spots

Fig. 60

*1 : Maintenance Spot

*2 : Maintenance Cycle and Contents

*3 : Details of Maintenance

0410-002 36

5.3 Maintenance Method

Reel Fulcrum Pin

Check and Clean with Each Product Change

Make sure there is no dirt (powder caused by

reel abrasion) on the reel fulcrum pin.

If dirty, remove it with a rag or air gun.

If the tape is fed while soiled

by reel abrasion, it might stick to

the greased section and so cause

a pick-up error.

Notice