OM-1058-002.pdf - 第74页

Tg0409-PM-SO 0410-002 73 7.1 Component Pick-up Error T able 12 7.1.2 A pick-up error always occurs Remedy : Clean the pick-up nozzle on the chip mounter main machine, as indicated in "V olume 4: Maintenance and Trou…

Tg0409-PM-SO0410-002 72

7.1 Component Pick-up Error

Table 11-2

Cause : Tape feeder not correctly set on the feeder carriage of the

chip mounter (TCM-X series)

Remedy : Set the tape feeder correctly on the feeder carriage of the chip mounter (TCM-X

series) according to the instruction manual.

Reference Page : Pages 24 to 30

If the tape feeder is used while it is rising, then that might damage the machine or lead to

pick-up error.

Attach the tape feeder securely to the feeder carriage.

(Error in locate lever attachment position, causing tape feeder to rise)

Notice

Cause : Tape feeder to be used is not matched with the compo-

nent

Cause : Suppressor not correctly set

Remedy : Use the component which is correct for the tape feeder.

Reference Pages: Pages 78 to 98

Remedy : Set the suppressor correctly, as indicated in the instruction manual.

Reference Page : Page 9 and 16

If the suppressor holding lever comes off while the tape feeder is in use, then it might cause

damage to the machine or cause a pick-up error.

Attach the suppressor holding lever correctly.

Front Hook Attachment Suppressor Holding Lever Attachment

Notice

Tg0409-PM-SO0410-002 73

7.1 Component Pick-up Error

Table 12

7.1.2 A pick-up error always occurs

Remedy : Clean the pick-up nozzle on the chip mounter main machine, as indicated in

"Volume 4: Maintenance and Troubleshooting" in the Instruction Manual

(TCM-X series) of main machine.

Reference Page :-

If the factory is dusty or if paper taping component is often used, then the pick-up nozzle and pick-

up nozzle filter can easily become dirty.

Keep them clean.

Cause : Dirty Pick-up Nozzle

Clogged Pick-up Nozzle Hole

Dirty Vacuum Filter

Note

Tg0409-PM-SO0410-002 74

7.2 Tape not fed

Table 13-1

7.2 Tape not fed

Remedy : Wind the cover tape around correctly, as in the instruction seals.

Reference Page :17

If the cover tape is not wound around correctly, it might cause a take-up error or feeding

error.

Cause : Cover tape not correctly wound around the roller section

Roller Section

Instruction Seals

Notice

Cause : Take-up reel socket not correctly set

Remedy : Align the reel drive locking position with the plate spring locking position, and

attach the take-up reel socket.

Reference Page :18

If the take-up reel socket is set incorrectly, it might come off during operation, and so might

cause malfunction.

Notice