OM-1058-002.pdf - 第28页
Tg0409-PM-SO Notice Fig. 44 • When the tape feeder is set, if the front hook section is separated be- cause of interference with the adjacent feeder , it might cause breakdown of the vacuum nozzle or machine. Make sure t…
Tg0409-PM-SO0410-002 26
3.2 Tape Feeder Attachment Procedure
Fig. 42
Fig. 43
For Small Reel
Mount the tape feeder body so that the tape
feeder front end is on the specified No. position
on the front feeder number plate.
For Large Reel
Attach the large reel holder to the specified No.
position on the rear feeder number plate.
Then mount the tape feeder body so that the
tape feeder front end is on the specified No.
position on the front feeder number plate.
Front Feeder No. Plate
Rear Feeder No. Plate
(2) Attach the tape feeder to the feeder
base with the specified feeder No.
Tg0409-PM-SO
Notice
Fig. 44
• When the tape feeder is set, if the
front hook section is separated be-
cause of interference with the adjacent
feeder, it might cause breakdown of
the vacuum nozzle or machine. Make
sure that the front hook is securely
engaged with the pin.
• If the front hook section at the end of
the tape feeder is bumped, it might
cause deformation and pick-up error,
because the suppressor holding load
is not given enough allowance.
Take the greatest care not to bump the
front hook section.
Bend Section
Fig. 45 Bend Section (Photo of TF-1210)
• Do not hit against an adjoining tape
feeder. Specially, 12 mm or more width
tape feeder needs an attention to
avoid deformation because there is a
bend in the shutter.
0410-002 27
3.2 Tape Feeder Attachment Procedure
Tg0409-PM-SO0410-002 28
(3) Push the locate lever in the direction
shown by the arrow in the figure and set
the locate pin on the feeder carriage.
A force of about 19 to 25 N (2 to 2.5 kgf) is
required to release the locate lever.
Fig. 46
3.2 Tape Feeder Attachment Procedure
(4) Make sure there is no backlash on the lo-
cate lever and that the tape feeder is fixed
securely.
When the tape feeder is mounted onto the
feeder carriage, lightly pull the locate lever in
the direction shown by the arrow in the fig-
ure.
Fig. 47
(5) After mounting the tape feeder, hold the
grip and lightly move it right and left to
make sure it is locked.
Fig. 48
Locate Lever
19 to 25 N
19 to 25 N
(2 to 2.5 kgf)
(2 to 2.5 kgf)
19 to 25 N
(2 to 2.5 kgf)
Locate Lever
9.8 N
9.8 N
(1 kgf)
(1 kgf)
9.8 N
(1 kgf)