OM-1058-002.pdf - 第37页
Tg0409-PM-SO 5.3 Maintenance Method 5.3.1 Description of Maintenance in Each Section Here the maintenance cycle for each section of the tape feeder . The described procedure takes for example a tape feeder of 8 mm width …
Tg0409-PM-SO0410-002 35
5.2.3 Preparation for Lubrication
Prepare specified grease and greasing tools.
• Specified Grease
Refer to "(1) Grease".
Before lubrication, wipe off the old grease.
Otherwise, the effect of grease will decrease.
• Specified greasing tools
Refer to "(2) Thin Bar".
(1) Grease
• DAPHNE EPONEX GREASE No. 1 (IDEMITSU KOSAN)
• NEW MOLYNOC GREASE No. 1 (Nippon Oil Corporation)
Same Type of Lubricants
• DAPHNE EPONEX GREASE No. 1 (IDEMITSU KOSAN) or its
equivalent
5.2 Preparation for Maintenance
Table 4
(2) Thin Bar
It is required for lubrication in narrow space. Prepare a bar with a
diameter of 1 mm.
Do not use a bar with a rough nap like a cotton swab.
• NEW MOLYNOC GREASE No. 1 (Nippon Oil Corporation) or its
equivalent
Table 5
Notice
Notice
Tg0409-PM-SO
5.3 Maintenance Method
5.3.1 Description of Maintenance in Each Section
Here the maintenance cycle for each section of the tape feeder.
The described procedure takes for example a tape feeder of 8 mm width
(except for TF-0814).
This applies to most tape feeders, except for those given special descrip-
tions.
How to Locate the Check, Cleaning, Lubrication and Adjustment
Spots
Fig. 60
*1 : Maintenance Spot
*2 : Maintenance Cycle and Contents
*3 : Details of Maintenance
0410-002 36
5.3 Maintenance Method
Reel Fulcrum Pin
Check and Clean with Each Product Change
Make sure there is no dirt (powder caused by
reel abrasion) on the reel fulcrum pin.
If dirty, remove it with a rag or air gun.
If the tape is fed while soiled
by reel abrasion, it might stick to
the greased section and so cause
a pick-up error.
*1
*2
*3
Notice
Tg0409-PM-SO
5.3.2 Maintenance in Tape Attachment and Product Change
Check and clean the tape feeder as required in tape attachment and product
change and by the condition of pick-up error.
0410-002 37
5.3 Maintenance Method
Fig. 61
Reel Fulcrum Pin (Fig. 62)
Tape End Detection Reflector (Fig. 63)
Sprocket (Fig. 67)
Shutter Driving Pin (Fig. 68)
Chute Section (Fig. 64)
Suppressor (Fig. 65)
Tape Peeling Section in Shutter Assembly (Fig. 66)