OM-1058-002.pdf - 第41页
Tg0409-PM-SO Fig. 65 0410-002 40 5.3 Maintenance Method Fig. 66 Suppressor Check and Clean with Each Product Change Make sure there is no foreign substance (chip component or dust) adhered to the rear side of the suppres…
Tg0409-PM-SO
Fig. 63
0410-002 39
5.3 Maintenance Method
Fig. 64
Tape End Detection Reflector
Check and Clean with Each Product Change
Make sure that the tape end detection reflector
is not dirty.
If dirty, remove it with an air gun or brush.
If the tape end detection reflector
is dirty, the tape end might not be
detected.
Notice
For Tape Feeder of 32 or 44 mm Width
(Photo of TF-4411)
Chute Section
Check and Clean with Each Product Change
Make sure there is no foreign substance (chip
component or dust) on the chute section.
If any foreign substance is adhered, remove it
with a rag or air gun.
If the tape is set with any foreign
substance adhered, it might cause
a suppressor deformation or
pick-up error.
Notice
Tg0409-PM-SO
Fig. 65
0410-002 40
5.3 Maintenance Method
Fig. 66
Suppressor
Check and Clean with Each Product Change
Make sure there is no foreign substance
(chip component or dust) adhered to the rear
side of the suppressor.
In particular, carefully check the corner section
because foreign substances can easily enter
there.
If any foreign substance is adhered, remove it
with an air gun, tweezers, or cotton swab.
If the tape is attached while any
foreign substance adhered to the
suppressor, the suppressor might
be deformed or a pick-up error be
caused.
Notice
Tape Peeling Section in Shutter Assembly
Check and Clean with Each Product Change
Make sure there is no foreign substance (chip
component or dust) adhered to the tape
peeling section in the shutter assembly.
If any, remove it with a rag or air gun.
If the cover tape is set with any
foreign substance on the tape
peeling section, the tape peeling
section in the shutter assembly
might be deformed or a pick-up
error be caused.
Notice
Tg0409-PM-SO
Fig. 67
0410-002 41
5.3 Maintenance Method
Fig. 68
For Tape Feeder of 32 or 44 mm Width
(Photo of TF-4411)
Sprocket
Check and Clean with Each Product Change
Make sure there is no foreign substance (chip
component, dust or fiber) in the sprocket.
If there is any such foreign substance, remove it
with a rag, air gun, toothbrush or tweezers.
If the tape is set with any foreign
substance adhered, the
suppressor might be deformed
or a pick-up error be caused.
For tape feeder of 32 or 44 mm
width, check and clean them also on
the other side.
Notice
Note
Shutter Driving Pin
Check and Clean with Each Product Change
Make sure there is no foreign substance (chip
component or dust) on the shutter driving pin.
Any component or dust dropped in the tape set
or removal might adhere to the greased section.
If there is any adhered foreign substance,
remove it with a rag, air gun or tweezers.
If the tape is set with any foreign
substance adhered, the
suppressor might be deformed or
a pick-up error be caused.
Notice