OM-1058-002.pdf - 第77页

Tg0409-PM-SO 0410-002 76 7.3 Cover T ape Caught T able 14 7.3 Cover T ape Caught Remedy : Replace the suppressor . Reference Page : Pages 13, 15, 59 and 62 If the cover tape is too forcibly pulled out from the suppressor…

Tg0409-PM-SO0410-002 75

Table 13-2

7.2 Tape not fed

Remedy : Replace the suppressor.

Reference Page : Pages 13, 15, 59 and 62

If the cover tape is too forcibly pulled out from the suppressor (tape peeling section), it

might be deformed.

Do not pull it so forcibly, but slowly lift the suppressor and so pull the cover tape out from it.

Take the greatest care in handling the suppressor (tape peeling section).

Cause : Loosen attached cover tape

Remedy : Turn the take-up reel to tense the cover tape.

Reference Page : Pages 19

If there is any sag on the cover tape, it might cause a pick-up error or feeding error.

Sag on the cover tape

Cause : Tape sprocket holes do not match with the sprocket pins

Cause : Tape peeling section deformed

Correctly tensed cover tape

Remedy : Align the tape sprocket holes with the sprocket pins.

Reference Page : Page 14

Cause : Tape feed spring lost its elasticity

Remedy : Replace the tape feed spring.

Reference Page : Pages 60 and 65

Tape Peeling Section

Notice

Tg0409-PM-SO0410-002 76

7.3 Cover Tape Caught

Table 14

7.3 Cover Tape Caught

Remedy : Replace the suppressor.

Reference Page : Pages 13, 15, 59 and 62

If the cover tape is too forcibly pulled out from the suppressor (tape peeling section), it

might be deformed.

Do not pull it so forcibly, but slowly lift the suppressor and so pull the cover tape out from it.

Take the greatest care in handling the suppressor (tape peeling section).

Cause : Tape peeling section deformed or scratched

Cause : Old tape is being used

Remedy : Replace with new tape.

Reference Page :-

When a tape becomes old, its characteristics are changed, e.g., its tolerance and adhesive

strength.

Tape Peeling Section

Notice

Tg0409-PM-SO0410-002 77

7.4 Tape cannot be set correctly

Table 15

7.4 Tape cannot be set correctly

Remedy : Replace the front hook.

Reference Page : Pages 59 and 61

If the front hook at the tape feeder end is bumped, it might be deformed.

That could lead to an insufficient holding load on the suppressor, which might in turn cause a

pick-up error. Take care not to bump the front hook.

Cause : Front hook deformed

Cause : As there is a foreign substance between the chute section

and the suppressor, the tape is not satisfactorily held.

Remedy : Clean the chute section and the suppressor and remove the foreign substance.

Reference Page : Pages 10, 39 to 40 and 43

If the tape is attached while any foreign substance is there, it might cause suppressor

deformation or pick-up error.

Always remove any foreign substance.

Chute Section Suppressor (Rear Side)

Cause :Deformed Suppressor

Remedy : Replace the suppressor.

Reference Page : Pages 59 and 62

The suppressor is an important component that can greatly affect the pick-up rate.

If the tape feeder is dropped and any excessive force falls on the suppressor, then the

suppressor might be deformed.

Take the greatest care to handle the suppressor.

Notice