OM-1058-002.pdf - 第27页

Tg0409-PM-SO 0410-002 26 3.2 T ape Feeder Attachment Procedure Fig. 42 Fig. 43 For Small Reel Mount the tape feeder body so that the tape feeder front end is on the specified No. position on the front feeder number plate…

Tg0409-PM-SO0410-002 25

3.2 Tape Feeder Attachment Procedure

Fig. 41

(1) Open the feeder work area safety door

of the chip mounter (TCM-X series).

Before the tape feeder is set onto the feeder

carriage, make sure that there is no foreign

substance or dust on the feeder base mount-

ing surface.

If dirty, wipe it off with a rag.

Refer to "2.2.3 Feeder Work Area Safety

Doors of Section 1" in the Instruction

Manual Volume 1: Operation (Operator) of

main machine for TCM-X series for details

of the feeder work area safety door.

Reference

Feeder Work Area Safety Door

Feeder Carriage

Open

Note

Tg0409-PM-SO0410-002 26

3.2 Tape Feeder Attachment Procedure

Fig. 42

Fig. 43

For Small Reel

Mount the tape feeder body so that the tape

feeder front end is on the specified No. position

on the front feeder number plate.

For Large Reel

Attach the large reel holder to the specified No.

position on the rear feeder number plate.

Then mount the tape feeder body so that the

tape feeder front end is on the specified No.

position on the front feeder number plate.

Front Feeder No. Plate

Rear Feeder No. Plate

(2) Attach the tape feeder to the feeder

base with the specified feeder No.

Tg0409-PM-SO

Notice

Fig. 44

• When the tape feeder is set, if the

front hook section is separated be-

cause of interference with the adjacent

feeder, it might cause breakdown of

the vacuum nozzle or machine. Make

sure that the front hook is securely

engaged with the pin.

• If the front hook section at the end of

the tape feeder is bumped, it might

cause deformation and pick-up error,

because the suppressor holding load

is not given enough allowance.

Take the greatest care not to bump the

front hook section.

Bend Section

Fig. 45 Bend Section (Photo of TF-1210)

• Do not hit against an adjoining tape

feeder. Specially, 12 mm or more width

tape feeder needs an attention to

avoid deformation because there is a

bend in the shutter.

0410-002 27

3.2 Tape Feeder Attachment Procedure