SMN-Tape Feeder Manual(Eng Ver5).pdf - 第47页
Operation of the T ape Feeder 2-17 2.2. Changing the T ransport Pitch 2.2.1. 8mm T ransport Pitch For the 8mm tape feeder , use exclusive feeder s of 2mm pitch and 4mm pitch respectively . 2.2.2. Changing the pitch of th…
Samsung SM-Series Pneumatic Tape Feeder Users' Manual
2-16
24~88mm Tape Feeder
For 24mm~88mm tape feeders, move the component to the tape pickup point using a
Manual Feeding lever.
The pickup position in the feeding direction is indicated at the side of the tape guide
with a mark as shown in the following figure. When performing pickup without
matching the pickup position, the head moving distance may become longer, reducing
the machine efficiency. In some cases, this may influence the part feeding.
Figure 2-21. Setting the pickup point of the SM 24~88mm tape feeder
Manual Feeding
Pickup Position Indication
Vinyl Removal Position
(Adjustable)
Operation of the Tape Feeder
2-17
2.2. Changing the Transport Pitch
2.2.1. 8mm Transport Pitch
For the 8mm tape feeder, use exclusive feeders of 2mm pitch and 4mm pitch respectively.
2.2.2. Changing the pitch of the SM 12mm, 16mm tape feeder
For the SM 12mm tape feeder, either 4mm, 8mm or 12mm pitch can be used depending
on the component types and for the SM 16mm tape feeder, either 4mm, 8mm, 12mm or
16mm pitch can be used depending on the component types.
Method of changeover: Set up on the cylinder bracket with the adjusting screw located on
the main frame as shown in the figure.
Figure 2-22. Setting the pitch for the SM 16mm tape feeder
Unscrew Bolt A slightly using a screwdriver with a ‘-’ shaped tip and remove Bolt B
completely. Then set the cylinder bracket pitch to the desired pitch (match the pitches of
4, 8, 12, and 16 with the bolt). Then tighten Bolt B and secure Bolt A.
Caution
Pitch change must be done in a clean place using proper
tools. Also, pay attention to safety and try not to damage
or lose components.
Volt B
Volt A
Samsung SM-Series Pneumatic Tape Feeder Users' Manual
2-18
2.2.3. Changing the pitch of the SM 24~88mm tape feeder
For the SM 24~88 mm tape feeder, either 4mm, 8mm, 12mm, 16mm or 20mm pitch can
be used depending on the component types. (If the user wants the transport pitch to be
24mm, 32mm, or 40mm, set the pitch to 12mm, 16mm, or 20mm respectively and rotate
the cylinder of the component placer twice.)
Method of changeover: Set up on the cylinder bracket with the adjusting screw located on
the main frame as shown in the figure.
Figure 2-23. Setting the pitch for the SM 16mm tape feeder
Unscrew Bolt A slightly using a screwdriver with a ‘-’ shaped tip and remove Bolt B
completely. Then set the cylinder bracket pitch to the desired pitch (match the pitches of
4, 8, 12, and 16 with the bolt). Then tighten Bolt B and secure Bolt A.
Caution
Pitch change must be done in a clean place using proper
tools. Also, pay attention to safety and try not to damage
or lose components.
2.2.4. Changing the pitch of the 24~88mm tape feeder
Unlike the 8~16mm feeder, the shutter of the 24~88mm feeder does not always perform
reciprocating movement during feeding but it determines and fixes the position at which
vinyl tape is removed when changing the vinyl removal position. Generally, minimizing
the exposure of a part by adjusting the vinyl tape removal position considering the pitch
Volt B
Volt A