SMN-Tape Feeder Manual(Eng Ver5).pdf - 第64页
Samsung SM-Series Pneumatic T ape Feeder Users' Manual 2-34 12. Peel off the other side of the adhesive su rface under the tape and rub it so that it sticks well. 2.5.4. Example of poor splicing When the tape is c…
Operation of the Tape Feeder
2-33
[View of splicing with a tip (Back side of tape)]
12~24mm Tape One –Tip 32~88mm Two - Tips
9. Cut the vinyl connecting tape by using scissors.
10. Align the vinyl connecting tape to the hole of the connected tape and place it on the
cut area. (Using the jig for vinyl splicing tape)
11. Peel off the adhesive surface under the tape from the side without holes.
Samsung SM-Series Pneumatic Tape Feeder Users' Manual
2-34
12. Peel off the other side of the adhesive surface under the tape and rub it so that it sticks
well.
2.5.4. Example of poor splicing
When the tape is cut with vinyl remaining on it
It may cause clogging of the slot for vinyl tape.
When the tape splicing face is not straight
If the splicing face is not straight
as shown in the left figure, it
causes an index error.
Operation of the Tape Feeder
2-35
When splicing the vinyl tape, check if the splicing tape provided from Samsung
Techwin is used.
When splicing the vinyl tape, if it is tied as shown in the above figure without using
the splicing tape provided from Samsung Techwin, it causes an index error.
Splicing tip is not used for splicing the paper reel.
If the tip is not used, it causes the point to bend as shown in the picture. Therefore, it
causes an index error.
When the splicing tape provided from Samsung Techwin is not used for splicing the
paper reel
If the splicing tape provided from Samsung Techwin is not used, the tape must be
overlapped for splicing as shown above. Therefore, since the thickness of the vinyl
tape becomes greater, it causes an index error.