SMN-Tape Feeder Manual(Eng Ver5).pdf - 第62页
Samsung SM-Series Pneumatic T ape Feeder Users' Manual 2-32 6. Place the tape to be connected on the tip and move the pressing device downward. 7. Connect the tapes by manipulating the handle of the tool. 8. Move th…
Operation of the Tape Feeder
2-31
[Greater than SM12mm]
3. Cut the H-shape tip to make it into I-shape.
4. Place the I-shape tip in the tool so that the burr is on the top.
5. Place the tape in use on the tip and move the pressing device downward.
Pocket containing a part
Pocket with no part
New Tape
Cut the reel at the center between
p
ockets
Samsung SM-Series Pneumatic Tape Feeder Users' Manual
2-32
6. Place the tape to be connected on the tip and move the pressing device downward.
7. Connect the tapes by manipulating the handle of the tool.
8. Move the pressing device upward. Push the handle of the tool and release it, and then
remove the connected tape from the tool.
[View of splicing with a tip (Front side of tape)]
12~24mm Tape One –Tip 32~88mm Two - Tips
Operation of the Tape Feeder
2-33
[View of splicing with a tip (Back side of tape)]
12~24mm Tape One –Tip 32~88mm Two - Tips
9. Cut the vinyl connecting tape by using scissors.
10. Align the vinyl connecting tape to the hole of the connected tape and place it on the
cut area. (Using the jig for vinyl splicing tape)
11. Peel off the adhesive surface under the tape from the side without holes.