SMN-Tape Feeder Manual(Eng Ver5).pdf - 第53页
Operation of the T ape Feeder 2-23 Pushing the grip forward, fix the feeder to th e feeder base. At this time, confirm if the feeder is firmly fixed to the feeder base. Caution If the movement of the grip is hard and abn…
Samsung SM-Series Pneumatic Tape Feeder Users' Manual
2-22
The method of installing SM 24mm~88mm feeder at the feeder base is as follows.
Figure 2-26. Inserting on the feeder base of the SM 24mm~88mm tape feeders
After confirming the slot number of the required feeder base, insert the SM feeder into
the slot, and push the feeder with adequate force until the location pin at the lower front
of the feeder and vertical plate of the feeder base contact each other. In the case of 24mm
and 88mm large feeder, pay attention to the slot number while inserting the feeder into
the feeder base as the feeder location pin is at the left side when viewed from above the
feeder.
Figure 2-27. Locking on the feeder base of the SM 24mm~88mm tape feeders
Operation of the Tape Feeder
2-23
Pushing the grip forward, fix the feeder to the feeder base. At this time, confirm if the
feeder is firmly fixed to the feeder base.
Caution
If the movement of the grip is hard and abnormal while
fixing the SM feeder into the feeder base by pushing the
grip, stop fixing the SM feeder into the feeder base for a
moment and check if there is any foreign material in the
feeder base slot. Fix the SM feeder into the feeder base
only when all conditions are normal.
2.4. Removing Feeder from Feeder Base
To remove the feeder from the feeder base, first confirm that the machine is in idle state.
Then release the locking of the feeder by pulling back the grip, grasping the handle with
the left hand, and removing the feeder while moving it backward.
Caution
Be careful as the feeder may become deformed or
damaged by falling, or by collision of the feeder tape guide
or locker with the feeder base at the moment the feeder is
completely removed from the slot of the feeder base.
Samsung SM-Series Pneumatic Tape Feeder Users' Manual
2-24
2.5. Splicing Tpae
2.5.1. Components for Splicing Tool Set
Splicing Tool
Splicing Tip
H-Type Tip (for paper) I-Type Tip (for emboss tape)
Vinyl splicing tape
(For 8mm tape) (For 12mm tape)
(For 16mm tape) (For 24mm tape)