SMN-Tape Feeder Manual(Eng Ver5).pdf - 第61页
Operation of the T ape Feeder 2-31 [Greater than SM12mm] 3. Cut the H-shape tip to make it into I-shape. 4. Place the I-shape tip in the tool so that the burr is on the top. 5. Place the tape in use on the tip and move t…
Samsung SM-Series Pneumatic Tape Feeder Users' Manual
2-30
2.5.3. Tape Connection Method (Emboss Type)
1. Cut the end part of the tape in use and the beginning part of the new tape by using
scissors.
[Greater than SM12mm]
Cut the reel at the center between pockets.
2. Peel off the vinyl tape on the leading end of the new tape (approximately 2mm).
Position for cutting with scissors Cutting the last end of the tape in use
Pocket containing a part
Pocket with no part
Tape in use
Operation of the Tape Feeder
2-31
[Greater than SM12mm]
3. Cut the H-shape tip to make it into I-shape.
4. Place the I-shape tip in the tool so that the burr is on the top.
5. Place the tape in use on the tip and move the pressing device downward.
Pocket containing a part
Pocket with no part
New Tape
Cut the reel at the center between
p
ockets
Samsung SM-Series Pneumatic Tape Feeder Users' Manual
2-32
6. Place the tape to be connected on the tip and move the pressing device downward.
7. Connect the tapes by manipulating the handle of the tool.
8. Move the pressing device upward. Push the handle of the tool and release it, and then
remove the connected tape from the tool.
[View of splicing with a tip (Front side of tape)]
12~24mm Tape One –Tip 32~88mm Two - Tips