SMN-Tape Feeder Manual(Eng Ver5).pdf - 第51页
Operation of the T ape Feeder 2-21 Figur e 2-25. Locking on the feeder base of the 8mm,12mm,16mm SM feeders Pushing the grip forward, fix the feeder to th e feeder base. At this time, confirm if the feeder is firmly fixe…
Samsung SM-Series Pneumatic Tape Feeder Users' Manual
2-20
2.3. Installing the tape feeder on the feeder base
Contact the feeder at the desired slot of the feeder base, and insert the feeder keeping the
installation guide accurately inserted in the feeder base slot. At this time, when the feeder
location pin located at the lower front of the feeder and vertical plate of the feeder base is
contacted, fix to the feeder base inserting grip.
Warning
When installing the feeder on the feeder base of the
machine, not checking whether the machine is in idle
status could cause severe injury. Be sure to check to see
if the machine operation mode is idle before installing the
feeder.
Caution
Since a large feeder is relatively heavy, special care is
required when transporting, installing, and removing it.
When installing the feeder in the feeder base or removing
it from the feeder base, use both hands. When
transporting and moving the feeder, exercise care to avoid
colliding with any object or person.
The method of installing SM 8mm~16mm feeder at the feeder base is as follows.
Figure 2-24. Inserting on the feeder base of the 8mm~16mm tape feeders
Each slot of the feeder base has its own slot number. After confirming the slot number of
the required feeder base, insert the SM feeder into the slot, and push the feeder with
adequate force until the location pin at the lower front of the feeder and vertical plate of
the feeder base contact each other..
When inserting the SM feeder into the feeder base, hold the rear part of the handle and
push the SM feeder as shown in the above figure.
Operation of the Tape Feeder
2-21
Figure 2-25. Locking on the feeder base of the 8mm,12mm,16mm SM feeders
Pushing the grip forward, fix the feeder to the feeder base. At this time, confirm if the
feeder is firmly fixed to the feeder base.
In the case of 12mm and 16mm tape, pay attention to the slot number while inserting the
feeder into the feeder base as the feeder location pin is at the left side when viewed from
above the feeder.
Samsung SM-Series Pneumatic Tape Feeder Users' Manual
2-22
The method of installing SM 24mm~88mm feeder at the feeder base is as follows.
Figure 2-26. Inserting on the feeder base of the SM 24mm~88mm tape feeders
After confirming the slot number of the required feeder base, insert the SM feeder into
the slot, and push the feeder with adequate force until the location pin at the lower front
of the feeder and vertical plate of the feeder base contact each other. In the case of 24mm
and 88mm large feeder, pay attention to the slot number while inserting the feeder into
the feeder base as the feeder location pin is at the left side when viewed from above the
feeder.
Figure 2-27. Locking on the feeder base of the SM 24mm~88mm tape feeders