SMN-Tape Feeder Manual(Eng Ver5).pdf - 第66页
在线预览 SMN-Tape Feeder Manual(Eng Ver5).pdf PDF 文档。
Operation of the Tape Feeder
2-35
When splicing the vinyl tape, check if the splicing tape provided from Samsung
Techwin is used.
When splicing the vinyl tape, if it is tied as shown in the above figure without using
the splicing tape provided from Samsung Techwin, it causes an index error.
Splicing tip is not used for splicing the paper reel.
If the tip is not used, it causes the point to bend as shown in the picture. Therefore, it
causes an index error.
When the splicing tape provided from Samsung Techwin is not used for splicing the
paper reel
If the splicing tape provided from Samsung Techwin is not used, the tape must be
overlapped for splicing as shown above. Therefore, since the thickness of the vinyl
tape becomes greater, it causes an index error.
Maintenance
3-1
Chapter 3. Maintenance
3.1. Maintenance of the Tape Feeder
Caution
Repair and maintenance need to be done in a clean and
safe place. If the feeder is handled with excessive force, the
feeder could be damaged. Pay attention to safety and try not
to damage or lose components. Be careful so that fingers
don’t get stuck during maintenance.
3.1.1. Lubrication and removing foreign matter
Mechanically moving parts are fully lubricated before shipment. However, because of
continuous movements, the duration of fully lubricated condition of the following parts is
short. Since these parts play an important role in tape feeder movement, they should be
checked regularly and kept well lubricated.
Caution
It is positively necessary that these areas (Shutter, Rachet,
Take-up Reel and Sprocket) are cleaned (Removing foreign
matter) and lubricated.
And Occasionally check if there is foreign matter.
Especially for 0603 feeders, the check should be carried out
with care because the supplied chip is too small to be found
easily by vision.
Clean the sprocket and ratchet of 8~16mm tape feeders with
air once a week.
3.1.1.1. Shutter area (8mm~16mm)
Remove foreign matter (chip) and apply the lubricant on the surface of the shutter
touching the tape guide so that it moves back and forth smoothly.
Grease Applying on 8~16mm Shutter
Including type of grease, method of application and indication location
Figure 3-1. Lubrication on the shutter area of 8mmand 12mm tape feeder
Caution
Do not apply grease on the tip of the shutter where shutter
and parts contact. Otherwise, error may occur while
supplying parts.
Shutter
Lubrication on
the shutter area
Lubrication on
the shutter area