Maintenance Reference(CP45FV) Eng.pdf - 第60页

Samsung Component Placer CP45FV Series Maintenance Guide How to use a grease gun Grease nipple-2(ea), Nipple tip-2(ea)   Reference Grease Gun Set : Grease gun-1(ea), Using a grease gun for the conveyo r and LSO unit, U…

Lubricant Method

4-3

 Wipe the utensil to take out the grease thoroughly and use. Do not use a wooden

spatula. If chips of wood get mixed up in the grease, severe problems could occur

 The oil separation phenomenon could occur in the grease left unused for a long time.

If this happens, mix it well before using it.

 If grease is taken out from the center of the container and the scooped up spot is left

untouched, the oil separation phenomenon gets aggravated as the gravity is

concentrated in the scooped up area. Raise the center area slightly and store.

 If the lid of the grease container gets damaged, moisture could penetrate or grease

could be oxidized due to contact with air. Take precautions.

Samsung Component Placer CP45FV Series Maintenance Guide

How to use a grease gun

Grease nipple-2(ea), Nipple tip-2(ea)



Reference

Grease Gun Set : Grease gun-1(ea), Using a grease gun for the conveyor

and LSO unit, Use the long type

nipple

Using a grease gun for the x-axis and

y-axis, Use the short type nipple tip.

1. Pull the cylinder lever back and fill

with grease.󰚟

3.󰚟Push the cylinder lever slightly and

remove the air in it using the handle.󰚟

2. Join the grease nipple and the body.

For the conveyor, LSO: long type nipple tip For the X-axis,Y-axis: short type nipple tip

4-4

Lubricant Method

4-5

4.2. Lubrication and Grease Application

Caution

It may shorten the average life span of a machine if grease

not specified by our company is applied on the machine.

Use the grease specified by our company.

4.2.1. Head

Inspection

Check the Ball Spline or the rail for discoloration or dust. 

 Noise may be generated if the lubricant has become too dry. Therefore, check the

state of lubrication.

LM Guide Rail

Ball Spline

Figure 4-1. Head Assembly Application

Solution

Remove any dust or foreign matter first and, if necessary, apply grease as thin as

possible on the ball spline or rail surface.



4.2.2. X-Y Frame

4.2.2.1. X-axis L/M Guide Rail

Inspection

Check the rail for discoloration or dust.

Check the lubricants on the rails. Insufficient lubricants on the rails could cause

unusual noise during operation of the machine.