Maintenance (Micron) workbook Iss07.pdf - 第53页

Issue 6, Nov 14 53 Objective SC4: Check moving sub-assemb ly home positions Using the technical reference manuals as a guide measure the home positions of each axis and complete the details below. Print Carriage ______ m…

52 Issue 6, Nov 14

Module M-SC

Settings and Calibrations

Issue 6, Nov 14

Objective SC4: Check moving sub-assembly home positions

Using the technical reference manuals as a guide measure the home positions of each

axis and complete the details below.

Print Carriage ______ mm to _______mm

Measured from the ____________________________________

to the________________________________________________

adjusted by ___________________________________________

Rising Table ______ mm to _______mm

Measured from the ____________________________________

to the________________________________________________

adjusted by ___________________________________________

Rear Rail ______ mm to _______mm

Measured from the ____________________________________

to the________________________________________________

adjusted by ___________________________________________

Note: There is no home setting for camera X and Y.

NOTES:

54 Issue 6, Nov 14

Objective SC5: Check board clamp setting

Using the technical reference manual check the board clamp operation and clearance.

NOTES:

Objective SC6: Check conveyor belts

Check the conveyor belts for damage and stretch.

NOTES: