Maintenance (Micron) workbook Iss07.pdf - 第54页

54 Issue 6, Nov 14 Objective SC5: Check board clamp setting Using the technical reference manual che ck the board clamp operation and clearance. NOTES: Objective SC6: Check conveyor belts Check the conveyor belts for dam…

Issue 6, Nov 14

Objective SC4: Check moving sub-assembly home positions

Using the technical reference manuals as a guide measure the home positions of each

axis and complete the details below.

Print Carriage ______ mm to _______mm

Measured from the ____________________________________

to the________________________________________________

adjusted by ___________________________________________

Rising Table ______ mm to _______mm

Measured from the ____________________________________

to the________________________________________________

adjusted by ___________________________________________

Rear Rail ______ mm to _______mm

Measured from the ____________________________________

to the________________________________________________

adjusted by ___________________________________________

Note: There is no home setting for camera X and Y.

NOTES:

54 Issue 6, Nov 14

Objective SC5: Check board clamp setting

Using the technical reference manual check the board clamp operation and clearance.

NOTES:

Objective SC6: Check conveyor belts

Check the conveyor belts for damage and stretch.

NOTES:

Issue 6, Nov 14

Objective SC7: Check rail-to-table height

Using the TB340 procedure and Co Planarity kit, check the rail to table height.

NOTES:

Objective SC8: Set vision height

Carried out in diagnostics - distance in millimeters from rising table home position.

NOTES:

Objective SC9: Check board stop X offset

Carried out in diagnostics - a measurement in millimeters which is entered in Maintenance

/ Machine Setup to allow board file compatibility.

NOTES: