EdisonStandardOwnersManual-RevA-20170818B.pdf - 第126页
P RINTER O PERATIONS Edison Printer User Manual (Part Number 1023838) 126 Rev. A Copyright © 2017 ITW EAE All rights reserved. No part of the contents of thi s manual may be reproduced, copied or transmitted in any form …
Edison Printer User Manual (Part Number 1023838) PRINTER OPERATIONS
Rev. A 125
Copyright © 2017 ITW EAE
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of ITW EAE, unless for purchaser's personal use.
5.7.4. Remove Empty Payout Roll
10. Remove the empty pay out roll with the paper core attached (Figure 123).
a. Do not remove the paper core.
b. Peel away the strip of tape
protector on the core.
11. Install this shaft with the paper core into the take up shaft location as shown.
a. Watch for proper engagement of the drive teeth
(Figure 124).
5.7.5. Install Fresh Roll of Wiper Paper
12. Place a fresh roll of paper onto the empty shaft and
reinstall collar (Figure 124).
a. Orient paper so it spools out from the top of the paper
and away from the operator (Figure 126).
Install collar with flat surface
against paper core.
Tabs opposite the collar are
designed to engage wiper
paper rolls that use a plastic
core.
Figure 123. Remove empty payout roll.
Figure 124. Reinstall Payout Roll with
proper alignment.
Figure 125. Reinstall collar
PRINTER OPERATIONS Edison Printer User Manual (Part Number 1023838)
126 Rev. A
Copyright © 2017 ITW EAE
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of ITW EAE, unless for purchaser's personal use.
5.7.6. Install Payout Shaft
13. Set the payout shaft into position and
watch for proper engagement of the drive
teeth (Figure 127).
5.7.7. Spool Out Wiper Paper
14. Spool out approximately 1 meter (3 feet) of paper as shown and then fold leading edge of
paper into an arrow point (Figure 128).
15. Feed arrow point over and behind the white wiper plenum (Figure 128).
Figure 127. Ensure proper engagement with Payout shaft drive
teeth.
Figure 126. Wiper paper spools out from top of roll and away from operator.
Edison Printer User Manual (Part Number 1023838) PRINTER OPERATIONS
Rev. A 127
Copyright © 2017 ITW EAE
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of ITW EAE, unless for purchaser's personal use.
Figure 128. Spool and feed wiper paper.
Figure 129. If wiper paper is properly routed, the notches of the back splash will be visible.
16. Secure the paper to the take-up roll cardboard
using either the pre-adhesive strip attached or
tape.
17. Re-install the roller shaft with the diamond knurl
pattern.
18. Verify the wiper paper is routed in accordance
with the routing label affixed near the wiper
assembly (Figure 130).
Figure 130. Wiper paper path label.