EdisonStandardOwnersManual-RevA-20170818B.pdf - 第159页
Edison Printer User Manual (Part Number 1023838) M AINTENANCE Rev. A 159 Copyright © 2017 ITW EAE All rights reserved. No part of the contents of this manual ma y be reproduced, copied or transmitted in any form or by an…
MAINTENANCE Edison Printer User Manual (Part Number 1023838)
158 Rev. A
Copyright © 2017 ITW EAE
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of ITW EAE, unless for purchaser's personal use.
6.2.22. Inspect Roller Plates–Monthly
Figure 156. Inspect Roller Plates.
Introduction
Inspect, clean, and lubricate the roller plates that the XYY alignment stage rests on (Figure 158).
Estimated Completion Time
Less than 5 minutes.
Procedure
With the printer under power go to Motion Control and slowly jog YL to an extreme.
Inspect and clean off the old grease that is visible on the plate and around the rubber skirt of
the roller.
Look for flaking of the finish or scoring of the plate.
o If the surface looks good, apply a light coat of Multis EP2 grease (or similar) in the
path of the ball roller.
o Jog through the grease a number of times.
Edison Printer User Manual (Part Number 1023838) MAINTENANCE
Rev. A 159
Copyright © 2017 ITW EAE
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of ITW EAE, unless for purchaser's personal use.
6.2.23. Inspect Inlet Filters –Monthly
Figure 157. Inspect Inlet Filters.
Introduction
Inspect the three air inlet filters and clean (Figure 157).
Estimated Completion Time
Less than 5 minutes.
Procedure
Open the front door.
Inspect the three air inlet filter screens mounted to the cover for the Main Control Module
(MCM). If these filters show dirt build-up:
o Remove the grills retaining the screen material.
o Vacuum and want the screen material as necessary.
MAINTENANCE Edison Printer User Manual (Part Number 1023838)
160 Rev. A
Copyright © 2017 ITW EAE
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of ITW EAE, unless for purchaser's personal use.
6.2.24. Inspect EdgeLoc+ System Springs–Monthly
Figure 158. Inspect EdgeLoc+ System Springs.
Introduction
Verify the condition of the springs used in the EdgeLoc + system for compliance monthly.
Estimated Completion Time
Less than 5 minutes.
Procedure
Each of the four springs (one at each corner) of the EdgeLoc+ assemblies are assist springs to pull
down the assembly when released (Figure 158).
Inspect and verify:
The springs are in place.
The springs do not appear stretched out.