X3_X4_Series machine.pdf - 第378页
7 Station extensions User manual SIPLACE X-S eries 7.1 Nozzle changer Software Version S R.601.xx 11/2005 US Edition 378 7.1.1.7 Notes on operat i on Æ When yo u fill a ma gazine wi th a certain nozzle t ype for the fi r…
User manual SIPLACE X-Series 7 Station extensions
Software Version SR.601.xx 11/2005 US Edition 7.1 Nozzle changer
377
– The Z axis moves up again and the nozzle is stripped from the sleeve by spring wires.
– The nozzle drops into the reject bin.
7
Fig. 7.1 - 6 Magazine and nozzle holders
(1) Fiducial for determining the position
(2) Locking plate in the "Magazine opened" position
(3) Nozzle holder
(4) Fiducial for determining the angular position
(5) Hole for the parallel pin for centering the magazines
(6) Hole for the parallel pin of the slide mechanism
(7) Slot for the parallel pin for centering the magazines
(8) Snap fastening for engaging the magazine into the nozzle changer
7 Station extensions User manual SIPLACE X-Series
7.1 Nozzle changer Software Version SR.601.xx 11/2005 US Edition
378
7.1.1.7 Notes on operation
Æ When you fill a magazine with a certain nozzle type for the first time, attach an adhesive label
to identify the type.
PLEASE NOTE 7
Fill the magazines off the machine and always replace complete magazines. 7
Æ Open the locking plate and place the nozzles in the nozzle holders.
Æ Close the locking plate so that the nozzles cannot drop out of the magazines.
CAUTION 7
Before you fill magazine, make sure that all the nozzles on the Collect&Place head have
been returned to their magazines. 7
PLEASE NOTE 7
Do not allow components to drop onto the magazines. If they do, they could jam the locking
plate. You should therefore regularly clean the magazines and free locations.
Æ Programming the nozzle changer is described in the SIPLACE Pro user manual.
7.1.1.8 Changing the magazine
Æ Press the lever (item 1 in Fig. 7.1 - 7, page 374) to release the magazine from the balls of
the snap fasteners (item 5 in Fig. 7.1 - 7
). Lift the magazine off the base.
User manual SIPLACE X-Series 7 Station extensions
Software Version SR.601.xx 11/2005 US Edition 7.1 Nozzle changer
379
WARNING 7
Any lever that is protruding over the magazine (item 1 in Fig. 7.1 - 7
) can result in a head crash.
You should therefore make sure that the lever does not protrude over the magazines.
7
Fig. 7.1 - 7 Changing the magazine
(1) Lever for raising the magazine
(2) Parallel pin, engages in the hole in the magazine
(3) Spring pin for triggering the microswitch
(4) Pin of the slide mechanism, moves the locking plate
(5) Ball of snap fastener
(6) Parallel pin, engages in the slot in the magazine
(7) Locking plate in the "Magazine locked" position