YSH20_Ope_E.pdf - 第110页
2-53 2 asic operation n W afer tray changer 1 Open the wafer tr ay changer screen. Press the [Unit] button and then select t he [W afer TC] tab to open the wafer tray changer scr een. 2 Extr act a tra y from the tra y …
2-52
2
asic operation
5.2 Operation check
After installing the feeders and making their settings, check to see if they operate correctly.
n
Tape feeder
1
Open the feeder screen.
Press the [Unit] button and then select the [Feeder] tab to open the feeder screen.
2
Select the feeder.
Select the feeder to check the operation.
TIP
You can select a feeder in the feeder layout diagram or from the feeder list.
Feeder screen
Selecting the feeder
Feeder list
Feeder layout diagram
24229-H0-00
3
Check the feeder operation.
Press the [Feed] button on the lower right of the screen to check that the tape is fed at the correct
pitch.
Feeder screen
Checking the operation
[Feed] button
24230-H0-00
n
NOTE
When a feeder with a pitch of 4mm or more is installed, check the top component and its position.
2-53
2
asic operation
n
Wafer tray changer
1
Open the wafer tray changer screen.
Press the [Unit] button and then select the [Wafer TC] tab to open the wafer tray changer screen.
2
Extract a tray from the tray changer.
Press the [Pallet Set] button to check whether a pallet is correctly extracted from the tray changer.
Wafer tray changer screen
Selecting a pallet
[Pallet Set] button
Enter a pallet number.
24233-H0-00
Chapter 3 Starting and ending production
Contents
1. Starting production 3-1
1.1 Resuming operation from the stopped point 3-6
1.1.1 Loading the saved data 3-7
1.1.2 Editing mount flags 3-7
1.2 Using the "block skip function" 3-8
1.2.1 Selecting the blocks 3-9
1.2.2 Starting operation 3-10
2.
Ending production and turning power off
3-11
3
3.1 Production 3-13
5
7
9
3.5 Alignment 3-21
3.6 Retry 3-21
2
2
3
3.10 Pick Rate Warning 3-24